stealth trans template

[wyattroa]

Just wondering if any has one? Or if people can drill them for you?
robert

[LowClassCC]

i have one as a lot of the guys around here. i'm sure i could let someone else drill it for me but its only 4 holes so not too hard to do yourself.

but here's how i see this post. you need a chassis drilled but don't have a drill template. if that's the case you have 22 hours left to be the proud owner of one of your very own. http://cgi.ebay.com/Vintage-Associated-stealth-drill-template-RC10-6590_W0QQitemZ130346912452QQcmdZViewItemQQptZRadio_Control_Parts_Accessories?hash=item1e59480ac4

[mikedealer]

i can vinyl cut you a template if you want? you can line it up and stick it on, let me know

[wyattroa]

i can vinyl cut you a template if you want? you can line it up and stick it on, let me know

That would be great! Im looking to put the stealth trans in. I have the original 6 speed in it currently. It goes about 25mph and im looking for a little more speed. I know the 6 gear trans is not as durable as the stealth.
robert

[mikedealer]

give me a hour or two to cut it out.

[wyattroa]

thank you so much..this site really is great.. not like most forums where you get harassed for certain things..
robert

[klavy69]

something I have done as brought about as suggestion by a few members here is to take a stealth chassis and bolt it to your non stealth chassis and drill it that way. Makes it perfect every time.
Todd

[wyattroa]

what size bit should be used?
robert

[klavy69]

1/8" works good for me...
Todd