New to the forums. I've been reading them for awhile and all I can is wow! Some unbelievable reads. Thanks to Jeff and Brandon for pointing me to this forum! We recently held a vintage race at the Georgia State Race. So I dug out my old hot trick RC10 and set about to getting it ready. Long story short, I had a blast wrenching on it and racing it again after twenty plus years of it being shelved! I'm researching my next RC10 project as we speak.
Well after searching for parts for the Rc10 I am building for a runner I found like most of you, certian parts are hard to come by. So I decided to hold off on some electronics for the runner and see if I can grab me another one. This is what I got...
Last post
Got some NIP 3 piece 1.5 rear rims screaming for that car!!!!!!
Just last week, there were some included in a lot of brushes and springs. I already have several comm sticks and didn't need a bunch of laydown brushes, so I passed.
hi, i was just wondering if anybody could tell me if and how i can strip paint of a pan without damaging the anodising? i have a nice pan with no scratches that has been sprayed blue over the top. it looks nice but for what i'm building i want the...
Last post
just in case anybody is ever wondering, paint stripper works fine. i left it soaking for quite some time and the anodising was totally unspoiled. the pan ended up looking like cr*p but at least the anodising wasn't spoiled :?
I have a Tamiya Avante in awesome condition.. it has been restored to the highest standards (mine!). Virtually every part is new, anything that isn't has been cleaned and restored and this car is everybit...
Last post
Cheers for the nice comments..
It is a LOVELY car - very pretty in the way that an RC10 is perhaps not..
As a racer at heart though - racing cars are what I collect, not these pretty, but probably more desirable cars.
Amazon [Bot] and 45 guests