I found the 1X on Novak's timeline on their website, but no specs. I can tell by the pots that it's forward only, but it's got some darn beefy wiring. Anyone know what the specs were? Cells? Turns?
I think I'm going to rewire it and use it for an on-road gold pan I want to build this winter, but am curious how hot I can go with the motor.
Thanks!
The preceding contained opinions, beliefs and thoughts that all may not agree with. No offense was intended at any point. Carry on.
Jeff
I have a Novak 4 ESC, the manual states the max current is 176 amps but doesn't give a recommended max motor turn. Recommendations? Also, the brake transistor is bad, before I start to Google the number on it, any known source? I usually buy from...
Last post
Wow! That is something. How long have that? Thank you, so there is a difference. The 4 is rated for 120A and the T4 is 176, a decent difference.
I picked these up last week to experiment with. They didn't really cost much at all and they work :twisted:
I can program the Cyclone with my own custom parameters or use one of the 20 saved Novak sets to use as profile 4 on the Cyclone. Too bad I...
Last post
Wait, you have a computer with a serial port and diskette drive? :wink:
I'm a Mac guy in all honesty, but yes I do. I found it in the garbage and put XP on it :mrgreen: I use it mainly for the old school Toyota Electronic Parts Catalog Software...
can anyone give me the specs on the original 10t, i.e. wheelbase and width. After seeing the sc10t build on here I was wondering what it would take to get the 10t up to current roar specs for the sct class
Last post
Thanks for that reply. How about some pics of your SC10T SteveK. I would love to see it. Please do post a few.
Just picked up an old buggy roller and it has a Peak Racing Illusion motor. Endbell says Epic on it and it appears to be fixed timing, but rebuildable. Any ideas as to the turns on this thing? My guess would either be 27 or 19, but don't know until...
Last post
Thanks. I got a minute to pull the motor and it said spec 27 on the end of the can. And, yes, it has bushings.
Would this be a decent motor if I cleaned it up and installed some bearings? The can reminds me of the Trinity Midnight2 and P2K that I...
I got a Sanwa M8 computer transmitter in a lot that appears to be working, except that the battery is very, very low. The charger was not included. Is there anyone who has the same transmitter and who could tell me what the specs of the battery...
Last post
I use an OLD Futaba transmitter charger for my M8 (with NiMh batteries installed):
Can someone here with Ultima & Turbo Ultima parts or experience provide me the following details? If you knew the stock gear ratio(s), that would be great too.