Andy's Arms- ??S on axles

[muck]

I want to use my Andy's arms off my graphite chassis. Are the B44 cvd still the correct length?

I see some using RPM GT rear hubs, any mods to fit those on the rear?

On the fronts, i see some using B4 hub, knuckles, and spindles. Will these fit with the Andy's?

thanks

[Charlie don't surf]

The arms and GT hubs will not accept the B44 CVA/CVD the axel is way to long- you would need to use a B2 CVD with the 3/16 axels to use that combo

[muck]

The arms and GT hubs will not accept the B44 CVA/CVD the axel is way to long- you would need to use a B2 CVD with the 3/16 axels to use that combo

shoot. I thought because the arms where longer than the stock ones they would work.
So if i stuck with the dog bone i have, is there an outer spindle to use?
Maybe i should ask this, is the dogbone that came on the edinger arms going to work on the Andy's?

thanks

[Charlie don't surf]

Yes but they are 1/4 in axels and you can forget using any current wheels. But you can get SC10 RTR dogbone outers that are 3/16 and use them

[muck]

ok, to recap then
using Andy's arms,
the stock dog bone from the edinger, sc10 spindle, GT hub?
sorry just want to make sure i am where i need to be with it..
thanks

[scr8p]

I thought because the arms where longer than the stock ones they would work.

andy's arms are the same length as stock rc10 arms, not longer.