Well, judging by the amount of cleaning your gonna be doing. I'll go ahead and recommend a ultrasonic cleaner. I bought one the other day from harbor freight for $30. I'm literally just dropping dirty parts w/o any cleaning and pulling them out a few minutes later nice and clean. Really helps get stuff out of hard to clean places.
I have lots of new hardware coming for this and a new front worlds tower. Also came with a Novak HP1 speed control and a Trinity Joel Johnson signature series mod motor.
Hi guys new to the site hi. I have just purchased a rc10 t after always wanting one
So the one I have looks In good condition the plastics are yellow I plan to whiten these ( any reccomendations are welcome ) and to powder coat the tub .
Also I...
Last post
Hey thanks for the info will the gt diff rebuild kit service the 10 t also
Will a set of replacement diff out drives fit the 10 t as I'm wanting some
For the build the truck is coming along nicely have had the pan powder coated
And whitened the...
it has been a while since have posted in this great forum, but now i have a little time to share my RC10 Worlds Car.
I have bought it on Ebay about a year ago, and have changed quite some things on the car.
It came in good shape, but i...
I got hold of an original RC10 Worlds (EUR 50, quite the bargain). I'm still torn between making it a shelf queen and building a runner for occasional low-traction track outings with a 13.5 T. Perhaps you could answer some of the questions below....
Last post
1. Soak all the nylon parts in water for a couple days to rehydrate them. The graphite parts should be fine.
2. You'll have to make the call on the o rings. They could be a few years old (re-re) or 30+ years old. If they feel okay, I'd probably...
I figured I would start a build thread on my 4-10 Legend 4wd RC10. Any questions or comments are welcomed. I have not done a build thread on here, so here goes nothing. This will not be a 100% correct restoration due to parts being very difficult to...
New forum member. I was hoping to get some advice on restoring an old gold pan RC10 back to running condition. The car is in good condition with Novak electronics and looks to be a pole position brushed motor. Tires are dry rotted from sitting over...
Last post
The 's' (as in 2s) are the number of cells, each are 3.7 volts, so a 2s battery is 7.4 volts (equal to the old 6 cell 7.2 nicd/nimh). The mAh is the capacity of the battery, the higher the number the longer the run time (also adds weight). The 'C'...
Here is my (new to me) Worlds rolling chassis. This was my first real RC back in the day and have regretted ever letting it go. However, I was able to get one again and thus my project car for this time in my life. Always been a Team...
Last post
I rebuilt the diff. That was the issue.
Drove it tonight in open practice and it did very well! Very happy with how it has turned out. :D
Hi guys,
I have an RC10 'WORLDs' car and after cleaning it up I'd like to ask for some advise on what parts i should be looking for.
I realy dont like the tie rods that are on this car. They look identical to the early gold pan items and the ball...
Last post
Losi makes a nice natural white (but not RPM white) heavy 4/40 ball cup, same length as the
RPM ones, and easy to find if you look hard the bottom worlds car in the pic has em' (before I found NIP AE ones--
Oozzee and 20 guests