Scratch-Built Car Stand w/Pinion Caddy

[LTO_Dave]

I wanted to make a car stand for my RC10 to use at the local track, and wanted to share what I came up with. I used a piece of scrap aluminum channel from work, drilled it with a hole saw, and tapped the holes for the 4-40 screws. I powdercoated it hot pink with a sparkle clear and added some foam and decals. The pinion caddy was a last-minute decision, but worked out great. It's not precision-engineered, but not bad for using only hand tools.

[THEYTOOKMYTHUMB]

Looks pretty sweet. Classic late 80s color choice too. And it holds 3 beers!

[Halgar]

Classic late 80s color choice too.

Well, sure, if you're a girl!

And it holds 3 beers!

Ok, so Dave gets to keep his man card, but only if those three beers are high octane barley wines that would put hair on the chest of even the wimpiest taster!!




Oh, come on, Dave! That shizznit was funny!

[slotcarrod]

Looks good to me, I like the FL pink!

[THEYTOOKMYTHUMB]

Umm... Halgar, your insecurity is showing again...