I have a two year old now and have gotten back into RC. I have my old childhood rc10 B3. I put in a brushless motor with amazing results but I would like to beef up the necessary bits for handling the new power. Advice is much appreciated 😊
Last post
For retro racing I upgraded my B3 to a b4 top shaft and slipper assembly, it's a straight swap and takes the strain out the single slipper pad that comes in the kit.
just wondering if adding the Robinsons Racing Optional Steel Idler Gear for the RC10-GT to my rc10 stealth tranny is a good or bad idea. The stock Idler gear for the Rc10 and Rc10-gt are the same part number (6507) so I assume the steel gear should...
Last post
Their site is worthless though. I think they sell on eBay now.
They don't produce that part any longer, and they're apparently hard to find.
I recently purchased the Dhawk metal case to replace the stealth on my Team Car. I was actually looking to just replace the idler gear because it had stripped the teeth on it. I bought the DHawk aluminum idler gear and diff gear. As I was looking...
Last post
Welcome aboard. :D
Dhawk Racing products are made in China which really isn't the global center of excellence for precision fit and finish.
In extreme cases when clearances are very large, I've also used JB weld to tighten the fit of bearings....
I was wondering if anyone has used a Dhawk Metal Transmission case?
How did it turn out, in terms of accuracy?
Was it a good choice of cases?
Last post
I recently purchased the Dhawk metal case to replace the stealth on my Team Car. I was actually looking to just replace the idler gear because it had stripped the teeth on it. As I was looking for the gear, I found Dhawks aluminum case and decided...
Anyone try a modern 17.5 brushless in a older 2.25 stealth transmission. I would be really curious to know how it went. It should be a lot easier to gear because of the lower transmission ratio. Please let me know if you have done this, how it felt...
Last post
What about rotating mass since both the diff gear and the motor pinion are going to be smaller for the 2.25 stealth?
Is there other associated truck tranny parts that will work/replace the #6585 clutch disk, #6584 outer hub and #6583 clutch hub for the stealth tranny? Anyone even have these replacement parts?
Last post
Why not buy this?
I believe when I first started looking they were all sold. I thought the newer one was a replacement...no biggy I always like upgrades! lol