Welcome aboard,
The complete car you bought looks like a very early Edinger car but it is missing some of the goodies. Light gold chassis, looks like a good start.
Have fun!
I did! The three chassis turned up today with a load of bits in too. What's the best way to clean the nylon parts? Boil them up in a pan with some washing powder?
in the last picture...I see some RPM/Andy's black arms, truck front white arms, maybe part of an MIP tranny? and a couple Losi rear bulkheads. I see a lot of 6 gear internals, but didnt notice any tranny cases
nothing is junk if you find a use for it!
--Joey --
Vintage A&L and Factory Works
Old School Racer & Vintage RC Car nut
JKRacingRC.com
where's all the build ups at? don't be shy. :wink:
Last post
just nice aft turnbuckles that fit the stealth model widearm rc10. out of all the parts and nuts and bolts and everything i have i swear some little gremlin came in and just stole my turnbuckle stash, i've ran plum out of them since i started...
Been a looong time. I see a LOT of the same Guys that were here when I was regular !!! My RC life, and collection, pretty much just froze since Ive been here, but a Buddy recently sparked my interest again. Mostly in some 1/18, 1/16, but they also...
I'm on oOple.com, newish member there (same username) who has recently got into vintage RC's. In particular i liked the RC10's i been seeing. Some of the examples on there look amazing, the original 80's box art looks so cool, proper...
Last post
Beware of what you read on eBay, it's ok to ask here about the cars you see there. That is not a 1994 Worlds car
because it doesn't not have the special black chassis which had grooves milled in the bottom of the tub I suspect for
lightening...
hello, im a pretty new to this rc stuff so i dont know what im doing yet, but i have a question reguarding an rc10 that i have. I'm pretty sure this has probably been asked before but can you run a traxxas brushless velineon 3500 motor with an rc10...
Last post
the stealth trans(3 gear) can handle a lot of power provided you pay attention to assembly, and adjust the slipper properly. Be sure the diff setting is correct and set the slipper on the loose side and sneak up to the desired setting.
so, here is my first post on this forum... If there is somewhere to intrroduce myself, just let me know ;)
I recently fell in love with the carbon fiber tub Fiber Lyte makes for the RC10. So I had to get a RC10... I had seen this car on...
Last post
Hi Matteo!
It's pretty nice indeed. I didn't want a worn car for this build as I want to make a shelfer from her... The plans are a Fibrelyte chassis and damper mounts, titanium turnbuckles, alloy wheels, a nice body (Proline if I can source...
Hello to all, newbie here, I just joined and got approved today 11-12-13. :)
I just started collecting these gems 2 years ago. Currently have RC10 gold tub Edinger and Graphite RC10 only. Looking forward to learn the tips and tricks, conversions,...
Last post
Definitely, ironic indeed. :D
Joey aka JKracing is the first RC10talk member I met in person.
The three chassis turned up today with a load of bits in too. What's the best way to clean the nylon parts? Boil them up in a pan with some washing powder?
