RC10Talk - The Net's Largest Vintage R/C Community

Isn't it Melbourne they say "4 seasons in a day" looks like all 4 are rainy seasons , try and keep out of the flooding as best you can , usually plenty of raw sewage in urban flood water , I used to have to recover cars from floods but after half the staff went down with bad vomiting and d...

Not dirty as such, just very very wet. This was before i sourced my Pro Radiant undertray (but was what instigated my search!) Moist. Screenshot_20221025-112028.jpg Screenshot_20221025-111948.jpg Screenshot_20221025-111841.jpg As long as she didn't go rusty again :D I love the rooster tail 8)

I looked at the pictures before reading the text and I was just thinking "he's been taking some tips from Ryo" .
Looks awesome as all his renders do , a credit to you're work too obviously .

Diamond Dave wrote: ↑Sat Oct 29, 2022 11:57 am Sweet sunrise.

Looks like a postcard

Been thinking of this for a while. I've got a fair pile of Coyote transmission parts and I've already CAD modeled the Tag Pro10 suspension but I want to take it a little further, I'm planning on changing around the front suspension to give the arms a 15 degree angle and doing something else with the...

Love the rear bulkhead great idea !

That's excellent work Mark , that radio tub took fantastic .
I know I go on about it but give those red nylon parts a good long soak in water , Hirobo nylon really does get brittle and the bulkheads snap at the lower suspension arm mounts regularly .

In the later Alien mid and Invader they used the same suspension geometry as the Zerda but significantly reinforced , the suspension arms are much thicker and the suspension mounts on the bulkheads are greatly reinforced , the suspension components for the Alien Mid and Invader are a drop in replace...

It's very easy to make those bumpers , it's just 3mm Kydex , you can get it on eBay , it softens in an oven at 150°C or if you just want a bend then a hot air gun works very well . Mark there is a piece of software called GOM Inspect that is often used in 3d scanning that compares digital models , I...

Welcome to the forum , looks like your going to fit in great , very lucky to still have your cars .

This is designed around Hot Shot axles as I had them to hand .

Ideally the pivot of the steering should be in the centre of the wheel , if it's designed that way in the first place then if you increase the offset with extending the hex hub further out then you should then use wheels with an offset that corrects it , in the real world unless your a pro driver yo...

I'm gonna say congratulations on your last restoration for a while

Welcome to the forum , there's an answer to virtually any RC car question you have here .

Like this.