if you have an LP servo, might has well get the link centered properly
Paul
AE RC10 - Made In The Eighties, Loved By The Ladies.
Blue Was Better - now, Blue Is Bankrupt.
Facebook affiliate program manager: "They go out and find the morons for me".
Life is short. Waste it wisely.
I changed out the rear suspension mounts because one was cracked, when I took the old ones out I noticed somebody had cut them down, why would they do that?
Also does anybody know what these black rims are? I striped one of them out and I bought...
Last post
Does that car have rear hex conversion?
Screenshot_20220809-042441_Samsung Internet.jpg
If so, use Traxxas 7171 wheels.
That's why I was curious about the axle picture. For rears with the 3/16 axle it seems easy enough to switch from hex to...
I have wanted one of these since my best friend from childhood had one in the late 80's. I picked this up on eBay last night, hope I didnt get hurt too bad at $300. It was advertised as an A stamp Andy's edition . What can you all tell me about this...
Last post
The tires for the 1.9/1.7 JConcepts can be hard to find at times.
They are overseas but JC Racing has wheel options for both axle sizes.
Alternatively, you can use the above 2.2 JConcepts fronts and Traxxas 7171 rears with Factory Works rear...
i was given a RC10 gold pan..............i need some parts (motors,shocks,radio gear/radio) and one know where i can get these parts for cheap ................... if you want to see my toy there's where you can find my pics of it
Enjoy
Smurf
Last post
hahahaha i didn't realize i had two.............i usually have so much going on at once it's easy to do
Hi Everyone,I recently aquired 2 RC10 gold pan cars with boxes 1 is a #6016 and the other a #6020 ,now from what I've come to understand the 6016 is a ball bearing equiped version of the 6020 don't know how true this but im am definitly addicted to...
Hello all, this is my 1st post on here. so here is goes I'm not new to rc's (I have 2 hpi bajas had lots of nitros and electric), my 1st rc was a rc10 gold pan and rc10t years ago (80's and 90s). I just picked up a rc10 gold pan and missing a couple...
Last post
going look at them now. guess i should have done that 1st :?
Hello new to the forum... I'm restoring an original A stamped gold pan with bushing transmission. Just wanted to see if I should go with a brushless set up or a brushed system. Will the transmission handle a brushless setup. Thanks.
Last post
Good brushed motors are inexpensive and you can still use LiPo's with many ESC's..... that's the route I'm going with my late CE restoration.
I'm sort of in the middle of a move. I've been selling off a lot of my rc10's and other rc cars. Went from 30 + vehicles down to less than 10. All of my white armed 6 gear buggies are gone. I thought I had a few stashed away :cry:
I had been...
Last post
Okay... so I may have been right earlier , that this was originally a Championship edition , 6001 kit. It has the offset non countersunk battery tray holes.
the original rear bulkhead & shock tower that was on it when I first got it was what lead me...
