Simple question here, what is the thread size for the RC10 Gold Pan shock shaft? I plan to get some aluminum rod ends, so I need the proper size (M3, M4, etc.) Thanks!
My son... ask for thyself another kingdom... for that which I leave is too small for thee.
Does anyone know of a rod end with a 3mm hole? Not the part that screws in the turnbuckle but the hole that the screw goes in. I have a jrx2 and I just hatched a plan to almost eliminate the slop in the 5 link.
HI!... Anyone know where I can get some of these ball rod ends? They have a ball on one end obviously but with a female nut on the backside that a screw goes into. I need two of them just like in the pic below.
Thanks :
Neal
Last post
As far as car purposes, associated used them on the sway bar. They are a DuBro aircraft part originally and have 100 uses
Which rod ends do you guys prefer for use on your vintage RC10s?
Anything I can simply click and buy to upgrade over the original ball and cup ends?
While we are here is there any other minor item like this worth upgrading before my new...
Last post
The Losi ones are pretty damn nice, the short RPM ones are my favorite, the JC and AE ones are garbage after the first time you take them off- super soft and flexible.
First, I have searched both the forum and google with little luck
1. Does everyone run/install the little foam washers/dust covers between the ball studs and the ball cups on their turnbuckles?
2. Can anyone recommend a good source for...
Last post
I live in a humid area and I noticed on the cars I had them on, the bottom of the ball studs were rusting. This only happened with the ones that had the foam dust donuts on them, and only where the donuts touched.
I got this on ebay not too long ago, happened to come across it by chance, bid really big on it and now have it, really well made and have no clue who if a person or a company made it.
Its so well constructed, just beautiful. I wanted to know if...
I am building a team car and would like to know if anyone knows the part numbers to use the modern factory team tie rods. There is so many, i dont want to waist money trying. Has anyone used these?
Last post
The camber links, front and rear, are 1.75 (#1404), and the steering rods are 2 (#1406).
i picked up a nip trinity #ev0017 ss front end kit. fits ev10ss,associated 10lss and bolink. it will bolt right on a 10lss but what bolink does it fit? does the bolink chassis need to be drilled?