Chassis stamping is under the motor not the transmission.DON
ps. READ the posting pics thread and you can go back an add the code in to make pics visible.
Hello, been a long time since I did any RC.. my 1st was a Tamiya Hornet, then I had a front wheel drive Kyoshia.. Always wanted an RC10 - well I finally got one!!!!!!
So now I need to get it working and don't really know where to start?
it has...
Last post
If you use narrow carpet tires, and trim off the inner bead of b4 front wheels and they will drop right on (bearing wheels)
I just picked up my first RC10 ( ) and I'm not terribly fond of the paint on the body. I'll be purchasing a new protech or similar body to work with. I'm wondering if there are any SIMPLE color patterns that are not too involved that a rookie could...
Last post
The yellow is a reproduction Protech 1. The blue is a JConcepts Detonator Worlds (the red car is as well).
Note that the blue car has a different front setup, requiring that the body be cut more.
IMHO, the JConcepts bodies have a little better...
Hi Everyone,I recently aquired 2 RC10 gold pan cars with boxes 1 is a #6016 and the other a #6020 ,now from what I've come to understand the 6016 is a ball bearing equiped version of the 6020 don't know how true this but im am definitly addicted to...
I have wanted one of these since my best friend from childhood had one in the late 80's. I picked this up on eBay last night, hope I didnt get hurt too bad at $300. It was advertised as an A stamp Andy's edition . What can you all tell me about this...
Last post
The tires for the 1.9/1.7 JConcepts can be hard to find at times.
They are overseas but JC Racing has wheel options for both axle sizes.
Alternatively, you can use the above 2.2 JConcepts fronts and Traxxas 7171 rears with Factory Works rear...
Here is my attempt to restore a gold pan rebuild. I took these photos with the Iphone. My plans are to run the B4 Wheel setup. I have a bunch of parts on the way: B44 CVA's, and Inline front axle setup. I want the gold shock bodies and will pick up...
Last post
beginning to look good ;)
if you have an LP servo, might has well get the link centered properly ;)
Hello all, this is my 1st post on here. so here is goes I'm not new to rc's (I have 2 hpi bajas had lots of nitros and electric), my 1st rc was a rc10 gold pan and rc10t years ago (80's and 90s). I just picked up a rc10 gold pan and missing a couple...
Last post
going look at them now. guess i should have done that 1st :?
I changed out the rear suspension mounts because one was cracked, when I took the old ones out I noticed somebody had cut them down, why would they do that?
Also does anybody know what these black rims are? I striped one of them out and I bought...
Last post
Does that car have rear hex conversion?
Screenshot_20220809-042441_Samsung Internet.jpg
If so, use Traxxas 7171 wheels.
That's why I was curious about the axle picture. For rears with the 3/16 axle it seems easy enough to switch from hex to...
i was given a RC10 gold pan..............i need some parts (motors,shocks,radio gear/radio) and one know where i can get these parts for cheap ................... if you want to see my toy there's where you can find my pics of it
Enjoy
Smurf
Last post
hahahaha i didn't realize i had two.............i usually have so much going on at once it's easy to do