OK ... I have two RC10 Worlds Cars. One is a restored all black car, and one is an in progress white and black car. This brings me to a few questions:
1) What was the point of the milled sections in the chassis?
2) Was the Worlds chassis really...
Last post
Well. I can tell you why the chassis were milled. One -was weight. Two -was to provide a channel under the batteries for the speedo wire. Three -was to provide a channel for dirt that collected in the car to find its way out via the holes. This was...
Like everybody else I'm building a WOIN Worlds car. To my knowledge everything is original. I've seen posts about the Klein arms, RPM Worlds arms, and CE arms. My question is, is the AE worlds arms the same lenght as the RPM Worlds/Klien Arms, or...
Last post
the b4 and b44 universals aren't that much different. If you are using the wheel spacers and b44 universals, you should be very close to where you need to be with b4 wheels. With b4 universals and b4 wheels, you should be as wide as a b4 +- a mm or...
Hi all. Nice place you have here. I have just completed my RC10 World's buggy. The only thing that seemed to be a problem was the transmission. It is notchy when you try to turn it by hand. I had read about the trans problems on this forum before I...
Last post
Long whip antenna....check! 8) I signed my autograph on the body to give it that finishing touch. :lol:
Well......I picked up a 'mostly' worlds car from ebay recently, kind of jumped the gun on the bidding, threw a hail mary bid, and actually won. I got the car but it's pretty beat. Looks like it was a solidly raced car. Kind of glad I just barely...
Last post
yep, they are not too bad, just worn from slapping the ground in the front and back. Those parts will be re-dyed black and used to replace parts I scavenge from some other cars I have.
My plan is to convert it to about 90% real black worlds car. I...
Ok, I preparation for my World's build up, these are the questions that I have come up with:
1. What color are the rear axle/bearing hubs? White or black? The manual shows the car with white, but a pic of the parts in black.
2. What color are the...
Last post
Got the rear wheels today qc, Thank you sir! Just need hoopty's Krylon or some white bell cranks.
Need some info on chassis. I know the difference in a slimline and a junior chassis (side pods and all), and between x2 and a pro chassis. My question is how does the wheelbase on the prose and the junior compare with the pro and the x2.
Reason...
Last post
hello,
The original jr chassis was about a half inch shorter than the pro/xt/jr2 chassis. Using this chassis will give you better steering, but the chassis only has a 20 degree kick. The later chassis have a 30 degree kick.
Ahrefs [Bot],