Hello!
Any difference between MIP RC10 4x4and Ten4?
Is Ten4 still available?
What is the rear transmission on the Ten4? The AE stock 6 gears transmission?
Thanks 🙏
Last post
Most parts are available but the most critical parts from Robinson Racing have a hard time sourcing. Most likely it might not be available. If I have the used piece on hand, I can ask the local shop to custom-made. 7075 and exotic plastic can be...
The Robinson Racing Ten4 shafts haven't been available for a little while. So I've decided to make my own. That opens up some possibilities, like adding a one-way bearing to the front pulley. I also found another source for the pullies that use...
Last post
good suggestions, thanks.
Part of the reason for needing to get the belt up is to clear the battery as well.
I think I finally have all the parts needed to start my Ten4. I wanted something a little different than a pan, and once I saw this AE graphite chassis I had my project! Since the chassis had a few extra holes drilled already, I knew that I wouldn't...
After 9 months of R&D, countless hours of design, printing, testing, and too many prototype parts to count, the Ten4 4WD conversion kit components are finally available! For the full story on the development of the Ten4 see the thread here...
Last post
I'll look into it.
Sorry everyone it's a bit of a PITA right now with all the parts listed individually. I'll see what i can do...
I just got this chassis off of facebook and wanted to do something special with it. I figured since it's too nice to run and MIP has a purple one out there, I might as well build a 4wd RC10 with it and the Ten4 will be a perfect project for it....
Last post
There are few different bone sizes available now for b5 and b6 that might be suitable now.
Probably going to make this the last Ten4 of my own. Robinson is out of the idlers now and I really don't feel like fabricating any. Going to take this opportunity to play with the build a little.
Short arm front end with mip style mono shock
A&L...