shapeways durability?
-
Mr. ED
- Approved Member
- Posts: 5483
- Joined: Thu Dec 21, 2006 1:30 am
- Location: Back @ home: Belgium
- Has thanked: 62 times
- Been thanked: 62 times
Re: shapeways durability?
http://www.oople.com/forums/showthread.php?t=156404
Probably a good option for anyone in europe.
Paul knows the requirements of rc and is probably more willing to communicate about print orientation etc. than shapeways or materialize.
I'm actually thinking about handing over my works 91 suspension arm design to him.
Probably a good option for anyone in europe.
Paul knows the requirements of rc and is probably more willing to communicate about print orientation etc. than shapeways or materialize.
I'm actually thinking about handing over my works 91 suspension arm design to him.
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 15 Replies
- 1783 Views
-
Last post by RC Chick
-
- 1 Replies
- 872 Views
-
Last post by slow_jun
-
- 12 Replies
- 1510 Views
-
Last post by GAMMACRUSH
-
- 8 Replies
- 849 Views
-
Last post by Frankentruck
-
- 1 Replies
- 1526 Views
-
Last post by Mark Westerfield
-
- 8 Replies
- 1351 Views
-
Last post by teman
-
- 10 Replies
- 1348 Views
-
Last post by kaiser
-
- 10 Replies
- 2908 Views
-
Last post by Dadio
Who is online
Users browsing this forum: No registered users and 8 guests