aeiou wrote: ↑Tue May 29, 2018 12:31 am
My battery plan has changed as the shorty battery I was going to use just isn't going to fit. The height is a tad too tall, but the bigger issue is the connector that falls directly under the belt. There's just no way to get one under there. So, I need to find a battery that'll fit lower and / or has the wires all on the passenger side.
There are dimensions in the link above but if you need more specific dimensions I have a few low profile packs from various manufacturers here at home that I could take a mic to if need be.
Hey guys, I singled out his buggy cause he said to fit the b4 body it required som serious tweaking. I was wondering people who have cut your pan, how much did you cut off. Like 1/4 inch?? Just wanna get a general idea on how much to cut mine....
Now that the anodized parts for my ReRe projects are in, it's time to get building!
I think I have most of the parts on hand to complete this one except for the new Lunsford Worlds Retro turnbuckles I just ordered and maybe a few other little bits...
Last post
what rear shock tower is that I like the wing mounts?
The rear tower is just a short World's 3mm tower from RC Carbon Works. The wing mounts are from the B5M kit (91531).
...The car is gorgeous, very stunning. Love the colors.
Looks good! ...?...
I’ve been wanting to build an RC10 trailing arm conversion runner for years as I’ve never actually driven one. I came close once with an A&L build, but when it was done, I just couldn’t bring myself to run an actual vintage chassis. When I saw that...
Last post
:D
I thought I'd post up these pics also, just in case someone finds them helpful. I tried all sorts of rear mounts for the Andy's Renegade body. The best solution I could come up with to deal with the angles on the rear of that body was a single...
Hello!
Any difference between MIP RC10 4x4and Ten4?
Is Ten4 still available?
What is the rear transmission on the Ten4? The AE stock 6 gears transmission?
Thanks 🙏
Last post
Most parts are available but the most critical parts from Robinson Racing have a hard time sourcing. Most likely it might not be available. If I have the used piece on hand, I can ask the local shop to custom-made. 7075 and exotic plastic can be...
The Robinson Racing Ten4 shafts haven't been available for a little while. So I've decided to make my own. That opens up some possibilities, like adding a one-way bearing to the front pulley. I also found another source for the pullies that use...
Last post
good suggestions, thanks.
Part of the reason for needing to get the belt up is to clear the battery as well.
Probably going to make this the last Ten4 of my own. Robinson is out of the idlers now and I really don't feel like fabricating any. Going to take this opportunity to play with the build a little.
Short arm front end with mip style mono shock
A&L...