gomachv's hobby room- then and now

[XLR8]

Good choice!

[jkelm24]

Nice, Jeff! HUGE step up from the Troutdale shed. Congrats!

Do you already have a compressor for the shop? I have one that's yours for cheap if you need one and have another Portland trip planned. Nothing special... 26 gal cast iron Husky - 2hp piston motor.

[jkelm24]

Double post - delete

[GoMachV]

Do you already have a compressor for the shop? I have one that's yours for cheap if you need one and have another Portland trip planned. Nothing special... 26 gal cast iron Husky - 2hp piston motor.

I have a big one picked out but waiting till the time is right (when money starts flowing again- aren’t we due for another stimulus check). I much appreciate the offer!

[GoMachV]

Getting closer. It’s almost presentable. The rubber base molding was remnant from a local carpet company and the crown molding was found in the garage rafters so it was free Still trying to decide if I wrap it with a trim line around the center, like checkered or ?? I don’t know it might just show off the irregularities better by doing it.