I'm starting to build my A&L chassis and want to do something a little different atleast. I have a buggy with what I believe is a A&L front shock tower for the RC10T. My question is, would it look alright on a A&L glass chassis kit?
that tower is for the monster truck conversion using 1.32 shock. i personally think it looks completely out of place for use on a buggy. if you like the looks of the taller front shocks, i would send daryl an e-mail and get the pro front tower for the 1.02's (part #2011 i think). it looks much better, imo. i had one on the a&l car i built awhile back.
I ran one on my buggy, using rear truck shocks. I liked it, made jumping a bit smoother. I have since swapped it out and returned my car to the std. Team car configuration.
Yeah, I thought it would help smooth out jumps a bit but this one will only do shelf duty. The buggy pictured though has a very interesting future I shall share soon .
Rebuilding 2 losis(1 junior t converted to jrxt and a jrxpro se mix part buggy converted to a junior2), as of now they have junior2/t front shocktowers.Been trolling ebay for a deal on a graphite/fiberglass font tower but I'm not sure what works...
Last post
My heads spinning, got dizzy had to sit down. :lol: I have a few old towers here. Not sure what your looking for but if I can help, I will. thanks ,but don't stress about it. looking for a jrx2 or jrx pro SE front tower. ill pm you if I get in need...
Never seen these before (tried to search here also) - This came with a graphite I bought while ago and it looks too nice to be home made. It seems like stamped or cut and not machined or drilled. Has anyone seen like before?
Last post
I measured the thickness and it's only 0.8mm. Material is also ferromagnetic, so something iron based. Probably it's someone's one-off custom part - quite decent looking though. Not sure if I am going to use it either...
I have a Fibrelyte RPM front shock tower that came in a job lot of carbon bits. I'm thinking of fitting it as part of a plan to use longer shocks and widen the front end on my Rc10 but i'm not sure what bulkhead is required for this one?
I'm looking for the graphite worlds front shock tower. I'd be interested in more than one.
Last post
Yeah, AE discontinued that tower. I tried to order a bunch of cool stuff like that from AE a couple months ago and it was all discontinued. They are still making most of the basic parts for the old RC10's, but slowly the supply is drying up.
not sure if its been done or tested, but i found 4-5 at my LHS and decided to give it a try, comes out perfect. Bottom needs about .5 mm sanded off, and then just holes drilled to match.
Last post
just to clarify too, you will need to take like 1mm off the bottom of the XX plate otherwise it wont sit right on the RC10 noseplate, i used a belt sander for mine