Left For Dead RC10 Team Car

[Charlie don't surf]

Did you run the new track Sat?

[Burntslapup]

Yes. It's a lot of fun to drive. Looking forward to running the B4.1 on it.

[Charlie don't surf]

We'll be there Sat for sure-

[Burntslapup]

I'm going to try and make it sat, but depends on work. They are going to do a buggy shoot out in Feb. I posted the idea of a vintage class. But no response from Will yet.

As for the RC10, I'm thinking of running the MIP steering stuff, and the hinge pins. Just having a hard time finding B2 CVDs.

[Charlie don't surf]

I have some, get up with me about Sat and I can bring them.

[Burntslapup]

Will do. Thanks.

[Burntslapup]

Started putting everything back together. Not happy with the way the chassis turned out but it will do till after the buggy shoot out next month. Now if only I can get Reggie to set it up for me.

[Burntslapup]

The almost completed RC10 Factory Team with a B4.1 Factory Team in the back ground.

[Charlie don't surf]

You living at the Best Western? I'm building Will one for the shootout too- bring it Sat if your coming and we'll see what else you need. BTW, you'll need to make some slicks like before.

[Burntslapup]

Yes liven in a Best Western thanks to a job that keeps me out of town a lot. I don't see me making it to the track this sat either, but hoping I'll get to race before the shoot out. I'm working on cutting the tires down to make slicks. As for parts i just need the front wheel bearings, rear hub bearings, and a white battery cup. I think I have the bearings at the house.

[Charlie don't surf]

You going to 3/16 cvds?

[Burntslapup]

I believe that's what they are. The buggy came with cvds and I had a set of T2 cvds. Gonna try and swap the dog bone out. Then use the T2's carriers and bearing. Or try and fit the T2 bearings into the buggys carriers

[Charlie don't surf]

Yeah, swap the bones and keep the entire T2 outer hub and bearings and axle-

[Burntslapup]

The T2 shafts and hubs are a great fit. Had to cut the battery cup so the hard case lipo would work. All I need now is the right sized front wheel bearings and it's ready to race. Also got the 17.5 brushless system installed but debating on switching to a Tekin Sport esc and a Brushed mod motor to top off the vintage feel. I'll get some pics up tomorrow. I'm excited to finally get this thing race ready and have enjoyed the rebuild.

[Burntslapup]

And here it is race ready or at least ready to run.