THE CHOP SHOP custom builds

[mrlexan]

It will be fine.... I REALLY want one of those! Don't be surprised if it comes up missing if you bring it in Sept.

[jasen]

badhoopty that looks awesome !

[Dr. Robotnik]

I made a 4wd kit for my RC10...

http://www.rc10talk.com/viewtopic.php?f=4&t=1937

Oh and the clod-sand-rail was woobergoober's then mine and is now back on tamiyaclub.com...

[rc-stu]

I made a 4wd kit for my RC10...

http://www.rc10talk.com/viewtopic.php?f=4&t=1937

awesome. i had to post some pics of it from your thread.

[Asso_man!]

Ed, did you think about getting the right ratio on the front drive train?

[badhoopty]

I made a 4wd kit for my RC10...

http://www.rc10talk.com/viewtopic.php?f=4&t=1937

Oh and the clod-sand-rail was woobergoober's then mine and is now back on tamiyaclub.com...

that homebrew 4wd is killer!!!!

[Dr. Robotnik]

Ed, did you think about getting the right ratio on the front drive train?

Yes, I think it may have been solved. By adding a Kyosho gear from this gear set (or similar) I think I can get a reasonable drive ratio at the front.



But although I've been watching this for months I haven't got round to buying it as my paypal doesn't work. However Mr.ED might be hooking me up with a used one to try out...

that homebrew 4wd is killer!!!!

Cheers Hoop!

[Mr. ED]

just noticed your pic is for a different car than my gear is of: I got an optima gear, not gallop.
Teethcount may be different but module should be the same.
To make it really work you'll need a bigger gear at the front, AND a bigger gear on the outside at the center axle.

[Dr. Robotnik]

just noticed your pic is for a different car than my gear is of: I got an optima gear, not gallop.
Teethcount may be different but module should be the same.
To make it really work you'll need a bigger gear at the front, AND a bigger gear on the outside at the center axle.

Yep I know all this But I just want try out a Kyosho chain gear to see if the tooth pitch from the Yoke matches the Kyosho stuff and if so then I can think about the solution further...

I have posted this question in the general forum.

[Chrominator]

Here's my Chop cut rebuild, a Tub with T3 suspension.
http://www.rc10talk.com/viewtopic.php?f=4&t=7023