'85 Gold Pan Resto-Mod...Need Some Advice Here!

[VINTAGE10]

Whoa...didn't expect that! That is a very kind offer, PBR, but before you go choppin' up a chassis, let's see what a01butal has to say about the templates he may have!

[a01butal]

I sent a pm with a scan of the template if that won't work I gave you info on how to get the real thing from me. Also you may want to learn about fitting the later Slipper assembly from I think a b3 or 4 and that would be an excellant hop up for the extra power.

[PBR Allstar]

I sent a pm with a scan of the template if that won't work I gave you info on how to get the real thing from me. Also you may want to learn about fitting the later Slipper assembly from I think a b3 or 4 and that would be an excellant hop up for the extra power.

Yup I did make the switch over to the B4 spur/slipper combo and it works amazingly. All you need is a few parts and your good to go.
Heres a list of parts you will need to make the switch.

• Spur gear 81T (9651)
  Slipper hub (9604) x2
  Slipper pads (9603) x2
  Top Shaft (9601)
  Slipper Spring (9605)
  Slipper locknut (6629) or a 5-40 locknut

As for using a complete B4 Stealth.....it won't work without alot of modding to both the tranny case and your chassis. You can still use your stock gear cover on this conversion......all you have to do is make sure you setup your slipper and then just mark and Dremel the excess off the top shaft end.

Heres a pic of what it ends up as.

[/quote]


here's the info on using the later B4 slipper setup on a first generation 2.25 stealth trans

[VINTAGE10]

Did I mention that I LOVE THIS SITE?! You guys are RAD...I'm gettin' all warm and fuzzy feelin'! This may be my last post for tonight, though, for I must sleep now. Thanks so much again! See yall tomorrow...

[justinspeed79]

I sent a pm with a scan of the template if that won't work I gave you info on how to get the real thing from me. Also you may want to learn about fitting the later Slipper assembly from I think a b3 or 4 and that would be an excellant hop up for the extra power.

Do you think you could send that to me also? Please. I want to put a stealth in my graphite runner. The only thing that's keeping me from doing now is drilling the holes. I'm sure I could do it without the template, but it would be nice to have it.

[justinspeed79]

I sent a pm with a scan of the template if that won't work I gave you info on how to get the real thing from me. Also you may want to learn about fitting the later Slipper assembly from I think a b3 or 4 and that would be an excellant hop up for the extra power.

Do you think you could send that to me also? Please. I want to put a stealth in my graphite runner. The only thing that's keeping me from doing now is drilling the holes. I'm sure I could do it without the template, but it would be nice to have it.

Actually, I just realized I have an old 10T chassis I can use. Thanks anyway.

[a01butal]

justin, just sent a pm with the template scans. Looks like you may not need them but it can't hurt to have some frame of reference.