Protech IV looks great on there. If you are planning to run it, the wing might get bent kinda easily with the narrow mounting pattern. You could use the outer set of holes to be more stable. For the shelf, it will be just fine.
Besides the kiddo's T3 build, I haven't really built ANYTHING in months :roll: :oops: :lol: so as some of you know a custom 10T-X is on the bench :mrgreen: I have a pretty good idea of what I want to build, just have sort out all the parts for it....
Last post
P1050515.JPG
By placing the mounts in the flat section in front of the angled up sides you have a narrow zone that will take all the stress.I suggest you add a link between the sides of the mount and chassis sides.
I hope you can make the body...
Thanks to the member that sold me all the Andy's parts on ebay. I had the chassis powder coated and threw in this ESC and motor to screw around...obviously too much. So, Andy's bulkheads, arms towers, battery cup (which takes a full size lipo BTW),...
Last post
Looks great all blacked out and the Savox servo looks like a perfect fit for the chassis.
this is another one of my builds that kinda sits on the back burner until all the right parts come along. i was able to get the rest of the andy's parts i need to put it together. i believe i have all of the andy's parts that they made for the rc10....
Last post
Well thanks for the reply, if you come across any more let me know :-)
A couple years ago, I bought a huge lot of Andy's parts which included several composite chassis, a ton of standard parts and some prototype parts. Everything was new, but a little dirty from sitting around for the past 20 years. Some of...
Last post
does the mip trans has a 4-10 conversion???
Unfortunately, it does not. That would have been a great build.
Well i think it's just lost it's value!! some of you might know this some not bought this a couple of weeks ago all NIP i was gonna part out then thought nah then needed $ that got straightened out so i thought i would TRY to build this i have some...
Last post
went and looked last night... def the same arms but no andy's logo or antying on the arms. Just the degress on the mounting blocks that attach the arms to the chassis... come to find out I actually have two different sets of them too! My chassis is...
Hey all. Here goes another build thread. Awhile back I was lucky enough to buy a new Andy's RC10T chassis. I don't know much about them, but they seem to be made of some kind of graphite material. The rear layout of the chassis allows you to run...
Last post
Did you ever finish this build?
Not yet. I just need to decide on wheels/tires and what body.