I got this in a trade about 10 years ago for some pan car parts. I used to run it all the time. It's time for a rebuild. I swear heard it crying as I was taken it a part. LOL!
Ritchie Mac
Last post
should be a 5mmx8mm bearing. manual shows the same size for front and rear diff's, both bearings in each assembly are the same.
Hey all, Thought I would show another side project i'm working on
This one is a TG-10 mk1 I got it as part of a bulk lot of 3 rc's in various
conditions It had the original Tamiya Subaru shell on it but well scuffed, the wheels had been replace...
Last post
Small update, received the new Battery box and the throttle servo mount parts that were missing. Still need to sort out the body mounts and a few other bits then she'll be done :)
:D Hey all, Thought I would show another side project i'm working on :roll:
This one is a TL-01 I picked up a few years ago, it came with the esc and Futaba radio already and worked well. In an effort to interest my wife in my hobbie (another 1 of...
Last post
Ok, so i've finished putting the chassis back together and fitted the new wheels to her :D I still need to fit the new body mount kit and the remaining radio gear :wink: Still progress made :lol:
This will sort of be a step by step rebuild of an OS engine.
I want to check the bearings as I put it away many years ago without after run oil and it was a bit gunky. It ran ok last time I used it a few months ago but it didn't feel 100% right,...
Last post
Thanks, I probably went a bit overboard but meh, it is what it is :lol:
Hey guys I’m new to the forum and am rebuilding my 1985 original RC10 I bought new for $185. Still have the receipt. I am looking for a few slam parts in the transmission. I need 2 new felt seals and I noticed one of the idler gears in the trans has...
Last post
I see 6633 and 6614 on eBay for $30 shipped ea. :shock: If you want to try and save a few bucks you can try Facebook r/c groups. I agree with the 3/8 x 5/8 outdrive bearing mod. We were doing those in the very early 90's when bearings were roughly...
After seeing slotcarrod´s thread about his B2 runner I did feel an urge to (try) re-build mine which obviously was a mix between a B2 and a B3.
Have been trying to suck in as much info as possible about the B2 and this is todays stand,...
Last post
looks great. I have been doing similar with an old B3, but my route was almost all used parts slowly building a runner for cheap. I close to finishing soon. I heard a few parts for these are available from Thunder Tiger via the Phoenix BX which is a...
So I'm slowly starting to go through the few cars I got and tonight's subject is an old RC-10 with a 6 gear transmission, A&L trailing arm suspension and Compiscraft (not 100% sure) chassis.
I forgot to take the pics when it was all...
Last post
Little bit of attention to the A&L trailing arms goes a long way.
Picked this junior-2 up super-cheap off ebay. it came with an uncut unpainted bluegroove body/wing/gear cover. The lot cost me about $15 more than TBG sells the body for.
I tore it down, cleaned and rebuilt it.
The paint is boxart inspired, I don't...
Last post
I wondered where my Junior 2 went! :mrgreen: You did get a hell of a steal on that one, find the missing top brace by chance?
Facebook [Bot],