i grabbed this off ebay a couple months ago (stole it in my opinion :wink: ). the front kickup was pretty beat up. the 2 outer arm mount hole on the left side were ripped out, and the right side was close to being the same way. now, i probably...
Last post
i'm sure there's more dust on it...... if that counts. :lol:
i was lucky enough to get hooked up with one of these (thanks hoopty :wink: ). it's in real nice shape, all except for the ton of extra holes that were drilled into it, and the LR arm mount hole was ripped out. so, i got them all filled, and the arm...
Last post
Well I now know what I'm doing with my Fibre-Lyte chassis set and that spare Team Car that I have, cheers Jason 8)
Lots of hop-ups in the tool box for this one. Not sure which direction i'll be going with this build but will do my best to add pics as I go.
Last post
Thanks for the reply JOHNBOY74 but for a while there DHAWK was selling them in silver. I contacted him but he was out. I was hoping someone on the board might have one in silver. I'd hate to try and get all the gold ano out of the nooks and cranny's...
Picked up this sweet rc10 team car with fusion speed chassis from Jason and added new proline wheels, new titanium turnbuckles, new early team car gear cover, new stealth outdrives and carbon transmission brace. I have a new painted Jamin Jumper...
Last post
That is an awesome car! The Fusion carbon fiber chassis is the unicorn of RC10 parts. I was lucky enough to find one of those tubs but it’s so rare I haven’t built anything with it yet
Got a very nice fusion speed tub drilled for a stealth. Not totally sure on the direction of this yet, any suggestions? I'm going to fill the 2 little holes on each side of the chassis then seal it with lacquer.
Hey Men, I'm starting a Fusion Speed Chassis build and going to go to the goodie box and dig out some of the best parts I can find for this build. We will see where this one goes... P3240393.JPG P3240394.JPG
New to the board and the RC10 but not new to RC. I am heavily involved in racing 1/10 and 1/8 offroad so I do bring a little bit of knowledge from there. That being said, I was born in 1985 and the RC10 is still pretty new to me. I am...
Last post
Yea I was thinking about it. Just not totally sure I wanted to go that route.
Was thinking of possibly trimming/drilling the front of the Andy's chassis for truck components. Not sure if cutting on that chassis would be a good idea though. Could...