i need a measurement of the battery strap from the end at the rear bulkhead to the mounting holes. also, the distance between the center of the 2 mounting holes. any help would be appreciated.
From the bulkhead end to the center of the screw holes is 4 5/8”. Screw holes center-to-center is 2 1/8”. Here’s a pick of the factory team version from my B4 runner (whittled down in the front for battery wire clearance). Just so happens, it also fits the old RC10s nicely, too…
i made a little mod to my b4 battery hold down strap. i thought i would share in case it is of interest to anyone. i don't know the various versions but i think this applies to the b3 and b4.
i liked the newer style with the 90 degree thumbscrew...
Last post
don't think of it as creative. think of it as something you want but not enough to pay the price.
My new batteries are a little taller/thicker which prevents the stock holder from going all the way down to hold it. Any suggestions on a different bracket to hold it down? Not so excited about velcro.
Thanks
Last post
My new batteries are a little taller/thicker which prevents the stock holder from going all the way down to hold it. Any suggestions on a different bracket to hold it down? Not so excited about velcro.
Fiest time the RC10 came out, it had fiberglass battery hold downs. And Two servo savers. Not one. Who can back me up onthis one. I know because I had it before.
...c'mon people...is this true or not? 8) :wink: :D
dose anyone know of an esc for brushed motors that can hold 10.8v and 17x2t motor i am looking for one to pretty reasonable priced i am not going to race most likely just want something that i can bash around with
Last post
if you are looking strictly fro brushed motors and not looking to go brushless, the novak super duty is the one to get. perfect for dual motor applications and up to 14 cells. available as factory refurbished for only $84
Note, I'm not asking how much something may be worth, I know that's verboten. The title is probably poorly worded. I'm just wondering if there's folks who still like to use old long-antenna crystal-based radios for nostalgia's sake? Personally can't...
Last post
I know someone with some yard tools to offer in trade.
Hey all,
Have used a set of calipers to measure the battery box within about half a mil
134.5mm x 47mm x 24mm
1) Has anyone found any lipo packs that fit?
Prefer hardpack/ROAR approved, but they all seem to be too big?
Yeah Racing 4000mah LP0042...
Last post
In my Pro SE I took my Losi hinged battery bar/box out of the front and replaced it with a Velcro batter strap (i used the same coutnersunk screws and put a hole in the velcro strap then used a washer and a nut on each side, and now combined with...
I now have available battery straps for my transverse shorty pack battery cups, printed in Nylon.
I'll make these available at Shapeways in the next day or two, but for now I have 3 available for immediate shipment. The price is $8 plus shipping....
Last post
The width is 1.86 , and the length is 3.80 .
I've run several brands of shorty packs in them and they have all fit nicely. 8)
