What RC10 chassis is this?

[Konich]

I just got this chassis off e-bay to finish my RC10 graphite box art, however who makes it? Its not a original AE, but I have no clue what company it is. It has the holes drilled for the stealth so I don't think its a Q10 chassis. Attached are some pics with what appear to be a lot of factory drilled holes (even for the old school wiper AE speed controller). Any ideas? Thanks again guys!

[mrlexan]

Since there is no glossiness to the finish and the corners aren't sharp, I don't think it is a AE/Horizon TQ10 chassis. It might be a Duratrax (or other aftermarket) graphite chassis.

BTW, the wing and the decal would be sooooo much better it is had a "talk" between the "10" and the ".com"

[aconsola]

This looks to be an aftermarket chassis. the tq-10 chassis was narrower in the area of the servo saver. Like the AE chassis and aluminum nose plate, there was a shoulder/step-off up just before the wider kick-up. The pictured chassis is the same width on the kickup as the flat.

[call-911]

My guess is Composite Craft, but I guess there were a lot of manufacturers that made graphite chassis for the 10.

[JPAE07]

I love that chassis. Nice find. That's a Composite Craft chassis for sure (99.99%). Houge made one similar but the rear portion was shaped for trailing arms.

[Asso_man!]

I would also say it's a CC chassis that has been drilled for a Stealth, nice find!

[Konich]

So for 30 bucks it was a good deal eh?

I'm actually going to finish it up and then on E-bay i goes!

[JPAE07]

So for 30 bucks it was a good deal eh?

I'm actually going to finish it up and then on E-bay i goes!

Doubt it will sell for what you think based on the reaction here. Why not try and sell it on the BST section here?

[a01butal]

Since there is no glossiness to the finish and the corners aren't sharp, I don't think it is a AE/Horizon TQ10 chassis. It might be a Duratrax (or other aftermarket) graphite chassis.

BTW, the wing and the decal would be sooooo much better it is had a "talk" between the "10" and the ".com"

Does that mean the request for RC10Talk.com decals is still in the works?

[JPAE07]

I think they are already available in a sticky at the top of the General Forum

[a01butal]

Not sure if you mean the ones that CafePress have but that's not the same as the original RC10Talk.com decals that were printed up before I was a member here. Before the Vintage Nationals someone told me that they would look into getting more out there after they returned from that weekend. Just a gentle nudge to remind that moderator.

[mrlexan]

I haven't forgotten..... trying to take care of the re-re body thing and setup some ebay clearance.

[a01butal]

Thanks, not a problem no particular rush just noticed your post above about the wing decal.

[n33no]

I haven't forgotten..... trying to take care of the re-re body thing and setup some ebay clearance.

He said re-re...

[scr8p]

it's a composite craft. they (that style) didn't come drilled for the stealth, so someone obviously did that. it looks like it was a mid motor setup at one time, too.