Rear axle size
Rear axle size
I recently bought a vintage gold pan with 6 gear transmission. I was wondering if someone could refresh my memory and tell me what the size of the axles are on these. Does anyone know if the modern wheels will fit with the truck conversion adapters on these axles?
Re: Rear axle size
They are 1/4" axles.
What i did to run modern wheels was:
Thunder Tiger Part PD8982 rear wheels
I used a #4 countersink on them as the 1/4" axles are tapered.
Put a small piece of heat shrink on the axle.
Install your wheel and you are ready to go.
This is for the buggy rear wheels, the truck conversion i am not sure about.
What i did to run modern wheels was:
Thunder Tiger Part PD8982 rear wheels
I used a #4 countersink on them as the 1/4" axles are tapered.
Put a small piece of heat shrink on the axle.
Install your wheel and you are ready to go.
This is for the buggy rear wheels, the truck conversion i am not sure about.
- AxleTT_opt.jpg (37.99 KiB) Viewed 939 times
- AxleTT_opt.jpg (37.99 KiB) Viewed 939 times
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 3 Replies
- 631 Views
-
Last post by mrlexan
-
- 13 Replies
- 3318 Views
-
Last post by scr8p
-
- 1 Replies
- 349 Views
-
Last post by RichieRich
-
- 0 Replies
- 646 Views
-
Last post by rccars4sal
-
- 5 Replies
- 968 Views
-
Last post by Brat
-
- 2 Replies
- 472 Views
-
Last post by illshou
-
- 9 Replies
- 2210 Views
-
Last post by Jeep-Power
-
- 4 Replies
- 759 Views
-
Last post by Boredome
Who is online
Users browsing this forum: No registered users and 22 guests