Rear axle size
Rear axle size
I recently bought a vintage gold pan with 6 gear transmission. I was wondering if someone could refresh my memory and tell me what the size of the axles are on these. Does anyone know if the modern wheels will fit with the truck conversion adapters on these axles?
Re: Rear axle size
They are 1/4" axles.
What i did to run modern wheels was:
Thunder Tiger Part PD8982 rear wheels
I used a #4 countersink on them as the 1/4" axles are tapered.
Put a small piece of heat shrink on the axle.
Install your wheel and you are ready to go.
This is for the buggy rear wheels, the truck conversion i am not sure about.
What i did to run modern wheels was:
Thunder Tiger Part PD8982 rear wheels
I used a #4 countersink on them as the 1/4" axles are tapered.
Put a small piece of heat shrink on the axle.
Install your wheel and you are ready to go.
This is for the buggy rear wheels, the truck conversion i am not sure about.
- AxleTT_opt.jpg (37.99 KiB) Viewed 1136 times
- AxleTT_opt.jpg (37.99 KiB) Viewed 1136 times
Create an account or sign in to join the discussion
You need to be a member in order to post a reply
Create an account
Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute
Sign in
-
- Similar Topics
- Replies
- Views
- Last post
-
- 3 Replies
- 726 Views
-
Last post by mrlexan
-
- 13 Replies
- 3719 Views
-
Last post by scr8p
-
- 1 Replies
- 394 Views
-
Last post by RichieRich
-
- 0 Replies
- 721 Views
-
Last post by rccars4sal
-
- 5 Replies
- 1168 Views
-
Last post by Brat
-
- 15 Replies
- 2291 Views
-
Last post by klavy69
-
- 2 Replies
- 663 Views
-
Last post by slow_jun
-
- 9 Replies
- 2486 Views
-
Last post by Jeep-Power
Who is online
Users browsing this forum: No registered users and 26 guests