Jammin' Jay's 6 Gear Rebuild

[rc10johnny]

Hey Guys, anyone have a copy of Jammin' Jay's tranny rebuild? Mines in storage....somewhere.....Thanks Johnny

[jwscab]

this one?

http://www.rc10talk.com/viewtopic.php?f=80&t=3748

[crazyfingers]

Is this the one?
http://www.rc10talk.com/viewtopic.php?f=80&t=3748

[rc10johnny]

Thanks Guys, now to print it off and on to two full bearing trannys Edit; do you guys drill and set screw the 3/8X5/8 or glue??????

[Phin]

...Edit; do you guys drill and set screw the 3/8X5/8 or glue??????

Neither. I use Jammin Jay diff tubes with squared off drive rings.

[rc10johnny]

Sorry! 3/8X5/8 bearings on diffs.....JohnnySr

[Phin]

Ahh you mean on the outdrives? Thought you were talking about pinning the drive rings.

On one side the motor plate holds in the bearing but on the other side I didn't glue or use a screw. I thought the screw was only for when doing the bearing elimination mod since without the screw the outdrive had nothing holding it in. Since I eliminated the bearing inside the outdrive a little differently I didn't need the screw outside the case to hold in the 3/8x5/8.

[rc10johnny]

Thanks Phin!

[crazyfingers]

I haven't raced a 6 gear car in over 20 years, but I always used blue locktite to set the rings. Some other guys used CA glue. I always thought the set screws would unbalance the gear.