I have found lots of front RC10 wheels made by Associated in black. But no rears in black yet. I just wanted to check - did they make rears in black? (For the buggy, NOT the truck).
Three piece, one piece, truck and buggy, front and rear were all made in black, yellow, and natural at one point. Just add a "B" or a "Y" to the part number for the colors
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas Factory Works website
you can also buy JC racing wheels that are 2.2" and fit on 1/4" axles, though they are 5 spoke. EDIT: Nevermind, I think you already have those based on pics in your other thread.
Yes I am going for flush original aero / dished style wheels now. But they have to be black. Fronts are sorted. Whatever black rears pop up for sale I'll just get the correct tyres / UJs to match. Thanks again.
I wanna say there were some black buggy rears (not sure if 3 pc or not) in the b/s/t section awhile back. Would be at least on page 2 by now if not pruned. Can't remember who but remember thinkin I should pick them up before someone else did since I don't see black rear wheels as much as black front wheels. Might be worth a shot checkin some older forsale threads though...
Todd
Peace and professionlism.....Kabunga signing off!!!
no, the hole through is the size of a #8 thread OD, 0.164", or somewhere close to that. Then you have the taper on the reverse side that goes up to 1/4" in the pin area.
HI !... Anyone have any good pics of the RC10's driver figure in boxart/manual colours? I'm starting to paint mine soon. From what i have seen, its basically like this :
- driver suit = RED
- helmet = WHITE
- cockpit = FLAT BLACK
- dash/steering...
Last post
there's a pretty good one on ebay:
how did yours turn out? it doesn't look like the box art driver is the lexan one included in the kit.
Hi guys,
After a bit of advice before spending my hard earned.
There is a one run old rc10t coming on the market soon.
But the chassis is anodized blue. I have never seen a blue tub before.
Could this just be that someone has anodized the tub, nose...
Ok i have some alloy wheels to mount on the front of an RC10, The axle size is 3/16, The wheel hole is 7/16. Anybody know were to get 3/16 X 7/16 Flanged bearings or some type of spacer to use 3/16 X 5/16 bearings.
Any help would be appreciated,...
Last post
I have 11mm bearings and they fit a little loose, Ill have to see if i can find some plastic adapters, i looked a little last night but had no luck lol