http://www.rc10talk.com/viewtopic.php?f=37&t=34040
First thing I did was mess with the rear suspension to make sure I could get some ground clearance out of it. I had to move the camber links to their lowest position to keep them from binding. I know the camber is all crazy, I think there is enough adjustment there to set it appropriately. I am also going to need to modify the upper or lower shock mounts to get the lift I'm looking for. Seems like good ground clearance for rally. This thing is built like a tank, so I think it will hold up well to some abuse. I still need to mess with the front suspension to make sure I can dial in more ground clearance.
![Image](http://i124.photobucket.com/albums/p29/mk-Zero/RC/20140222_171736_zps18da8d98.jpg)
Next I yanked out the engine and fuel tank to see is a battery would fit. Looks perfect!
![Image](http://i124.photobucket.com/albums/p29/mk-Zero/RC/20140222_171843_zpsdc426275.jpg)
I'm going to mount a brushless motor where The receiver battery pack and throttle servo were. Just need to shorten the top plate, piece of cake.
I need to figure out what to do with the 2-speed to make it a single speed and eliminate the clutch and one-way so I have reverse. Any ideas would be appreciated.