RPM 7062

[bully]

Hi all i ordered a set of nip RPM7062 rear arm mounts the other day from a shop over east i paid $23aud posted, i just checked them an they obviosly don't fit the RC10T.. Do people use them on a 10T by drilling one new hole or have i wasted my coin as i suspect i have? I should have checked with the brains trust first i think...Doh

[Charlie don't surf]

Askbob just ran into the same snag with a set, if they can be drilled to work I would-

[scr8p]

Those are the ones for the t2, right?

[Charlie don't surf]

yep

[bully]

Thanks guys I thought if the 7363 was T2 and 10T applicable that the 7062 would also work but you get that,never know I may get a T2 one day.. I have decided not to butcher them and to just keep them... Thanks for the help guys...

[RC10th]

I'm struggling to figure out why they wont work. I've tried looking for a photo and browsed the RPM website without luck.

How can they not fit? 10T/T2 arm mounts are interchangable. What's so special about the RPM ones that they wont work?

[RC10th]

Nevermind, I'm an idiot. The T2 uses the two outer most holes. The RPM ones must only have 2 holes to suit T2.

[scr8p]

ya, the t2 rpm mount only has the outer holes.

[bully]

RPM 7052 are the 10T specific mounts I have found out thanks to a fellow member.. In case anyone was wondering...