In my first post, I said this would be sitting on my shelf in 2019. So, I figured I'd better get going on it.
I've been slowly collecting parts for this. Other than bearings, some hardware, a couple hinge pins, and a diff rebuild kit, I have basically everything to make it a roller. Since I had to dye some parts red for one of my Masami replicas, I got the trans case done for this one right away. And then, Moved on to the Shapeways parts....... which I was kind of dreading. I'm not
super happy with how they turned out, But they're not bad.
So on to a little bit of the mock up so far.