Need ref for this part

[prp]

Hi guys,

Well I search the right ref for this part, it's not the ZC 432 like on the pic:

$_12.jpg (32.09 KiB) Viewed 1473 times

$_12.jpg (32.09 KiB) Viewed 1473 times

Thanks for help and if any body have this

[scr8p]

They look like the right adapters to me. Unless I'm not understanding what you are asking.

[prp]

I ordering ZC 432 and they're not the same like you or the pic

[jwscab]

post a pic of the 'wrong' part and maybe we can decipher what it is. likely had the wrong header card installed?

[prp]

I have this one for the ZC 432

[Mr. ED]

Ah, we are playing 'spot the difference'... I think what you're trying to show is the height of the cylindrical part? There is much less material above the thread for the setscrew on your part than on the others. Right?
Maybe that was a running change over the production period and they did not make a new partnumber for it?

[jwscab]

That is rather strange. They look to be about 1mm wider than the stock photo, then the center part is trimmed back some.

[fakiee]

I just thought Yokomo used the same part number along their timeline, could be way off here??

• the part is correct at the time of the 870c - front hub
  
  Used same part # at the time of Works 94 - front hub

[aip47-2008]

I have this one for the ZC 432

The attachment rsz_dsc03351.jpg is no longer available

That part is actually different. Part Number ZC-432D As shown below.

[jwscab]

There's the guy with the answers( and I swear every yokomo part ever made).