Will any MIP Pucks work with RC10GT?

[PerryCodes]

I had originally thought this would: http://www.miponline.com/store/mip13130.html

What do the experts say?

If not, is there another Pucks product that would?

[scr8p]

They don't have a kit that will work in a GT.

[Twistedaxle]

That should work. The GT, T2 and T4 all share the same diff

[scr8p]

The puck system is for the 4.1 with metric outdrive bearings.

[Twistedaxle]

The puck system is for the 4.1 with metric outdrive bearings.

ah Crap egg on my face, I completely forgot they switched transmission cases and went to metric. My bad sorry guys

[PerryCodes]

And that's what got me thinking that MIPS 13130 would work... They say it's for the SC10, T4... which if that were true, it would NOT be metric.

As has been recently discussed, they went to metric for the .1 and .2 releases. Egg on MIP's face, not you! The first time they mention that it's for the later models is down in the Compatibility section!

[sbcnyc]

if you read the descriptions on mip's site

COMPATIBILITY:

Associated T4.1,T4.2, SC10 Factory Team, SC10.2, this also includes any and all T4/SC10’s if they have AE part # 9826 transmission case.

the 9826 case uses the metric outdrive bearings... even if the puck outdrives fit the gt/t2 cases, the t4 bones across the board are too long, add the thickness of the puck vs a standard dogbone pin and you have one locked up setup!

but hey... there on closeout for 15 bux... someone here has to have the tools, skill and patience to machine the outdrives and shorten the bones...