XLS re-release build.

[winner_evo]

Electronics to fit next, here's whats going in...




A Hobbywing Quicrun 120A sensored esc, SpeedPassion 8.5 motor (hope I have better luck with this SP motor than I did with the last), Savox 1251MG low profile servo (I have one of these in my TC5), Futaba 2ch. 2.4ghz receiver (I have these in all my cars) and a CORE RC shorty lipo ( which doesn't fit )

[XLR8]

The car looks great and those are some really good choices for electronics. I have the same ESC but for the motor I'm going to try a Trackstar 10.5. I just need to set other projects aside and finish it.

[winner_evo]

Been busy over the weekend getting this rapped up. There's a lot less space for the electronics than first appears as the posts for lipo straps are in the way of the esc so I had to tuck it under the upper deck between the posts. This then took up the space for the receiver but the the low profile servo made a some space for that.

12AWG motor wires only just fit inside the body...

[winner_evo]

Painted up the body with Tamiya rattle cans. I'm no painter and the first time painting stripes, not so easy with the wide spray pattern from the can and a few mistakes here and there.

BITD a club member painted the body for my old car, I just told him white with yellow & blue stripes and left the design up to him. I chose white, yellow & blue as they were the colours of the Williams F1 team at the time








I used Tamiya PS1, PS4 & PS6. I guess the the only thing left is to take it out and run it when I have some time.

[DennisM]

Looking good

[scr8p]

[Danf1275]

Looks good, lots of boxarts and variants out there now (including mine), so it's nice to see something different.

[XLR8]

I agree, it looks great Winner. The paint scheme really takes me back. Well done!!

Actually, now that think about it, I used to have a golf shirt with those stripes. Little did I know at the time, I was sporting Williams F1 colors.