Tamiya Torque Tuned motor

[XLR8]

I have a couple new Tamiya kits that include this motor and was wondering if they require any kind of break-in procedure -- the manual doesn't mention it.
I'd like to run the cars in box-stock configuration and want the best possible performance with the kit motor.
I'm guessing the motor is run-tested by the factory so maybe it doesn't need anything further to seat the brushes but what do ya'll recommend?
Thanks.

[perry]

I still like to run brushed motors in clean water on 3v for a few minutes to seat the brushes. That way the debris from the initial cut in washes out and doesnt build up inside the can

[XLR8]

I haven't ran a brushed motor for a while and I've totally forgotten about the water break-in method. I'll give that a shot. Thanks Perry!!

[Wazza22]

I still like to run brushed motors in clean water on 3v for a few minutes to seat the brushes. That way the debris from the initial cut in washes out and doesnt build up inside the can

Thats a good point, I hadn't considered the crap filling up the motor in initial break in

[TRX-1-3]

RCCA Pit Tips Jim Newman style. I saw that illustration of the motor in the jar of water and my head exploded!

[perry]

RCCA Pit Tips Jim Newman style. I saw that illustration of the motor in the jar of water and my head exploded!

Yep, back then some of would make a 3 cell nicd pack to break in motors

[RC10th]

Or stick a wrench in and tweak the com

[Incredible_Serious]

Or stick a wrench in and tweak the com

Trump-style.......

[RC10th]

Or stick a wrench in and tweak the com

Trump-style.......

Grab em' by the........ pinion