Composite Craft RC10T chassis dirt oval car

[MarkyDents]

Finally had the chance to check this car out after receiving it. Pretty cool piece, interesting mix of parts that seem to come together nicely. I’m still amazed at the various platforms you could have and still can come up with based on the almighty RC10 !! Only thing I’ve done so far with it is pull some double stick tape off of the chassis and throw on the front wheels and tires. So now what ? Just clean it up and leave it the way it is ? Outfit it with some proper electronics ? Tear it down and use the parts to make an interesting tub based RC10 ?
Let me know what you would do. Thanks

[RC10resto]

So now what ?
Just clean it up and leave it the way it is ?
Sounds good
Outfit it with some proper electronics ?
Sounds good
Tear it down and use the parts to make an interesting tub based RC10 ?
Sounds bad

[THEYTOOKMYTHUMB]

Yeah, no way I'd turn that into a tub. LTO!

[MarkyDents]

I’ve just realized this front bulkhead is for an Ultramold, am I thinking this would be the only other good use for it considering it’s design and it’s inability to retain a CC worlds chassis upper or an RC10, and RC10T’s stock nosetubes.

Did RPM ever produce a stock design T front bulkhead ?

[juicedcoupe]

Did RPM ever produce a stock design T front bulkhead ?

In the Worlds front kit, they list the bulkhead as an AE part.

[scr8p]

RPM didn't have a truck bulkhead that accepted nose tubes. The one you have is it, so ultra molded or carbon chassis is about it.