Composite Craft Worlds Car Graphite Chassis set

[transamman908]

I have a nib Composite craft worlds chassis and would like to build and complete it. I have found some photos and other info on here, but still have qhestions. I know that a rc10t or gt front bulkhead will be needed. What arms do i use and do they have to be rpm's? Also, can a stock rear bulkhead be used? Basically i'm looking for a list of parts needed to complete this as far as suspension parts. Thanks

[scr8p]

if you don't have rpm worlds arms, your only other option would be the dynotech klein replacement arms (part #2700/2701). as for the rear bulkhead, a stock one should be fine. you may have to notch the side of the battery box area for clearance for the a-arms. you'll probably want to look for the worlds rear hub carriers, or the rpm rc10gt rear hubs will work. on the front, yes, you'll need a 10t/gt front bulkhead, rpm worlds or dynotech arms, and you can use the stock associated castor blocks and steering knuckles/axles.

don't forget the worlds rear arm mounts, too.

[transamman908]

Great, Thanks. I also notice that my chassis has a small notch by where the steering servo would mount. Why is it there, I don't notice it on others i've seen.

[scr8p]

that's for servo saver clearance. i don't remember ever seeing a "worlds" chassis that didn't have that cut out.

[scr8p]

...... other than that one in the ebay section.

[transamman908]

I was checking out the post in the ebay talk section and noticed it, but maybe it's not a worlds chassis

[scr8p]

no, it's a worlds chassis. it could just be an early version..... or something like that.