RC10 B1 Aftermarket Narrow Front Arms?

Post by **morrisey0** » Fri Mar 17, 2023 8:42 am

Was there a such thing? Looking at RPM and Andy's, I am only seeing what look to be wide front arms. Any options?

Post by **MarkyDents** » Fri Mar 17, 2023 8:54 am

Andy’s Oval front arms were the same width as them.

: 4E7F79FF-9209-4722-A4A5-67F7FBC0B38A.jpeg (58.05 KiB) Viewed 349 times

: 4E7F79FF-9209-4722-A4A5-67F7FBC0B38A.jpeg (58.05 KiB) Viewed 349 times

: 3D738F2A-C4BB-4909-9BC8-0EC25BA5BC20.jpeg (35.94 KiB) Viewed 349 times

: 3D738F2A-C4BB-4909-9BC8-0EC25BA5BC20.jpeg (35.94 KiB) Viewed 349 times

These pictures were pulled from other threads on the subject

Post by **morrisey0** » Fri Mar 17, 2023 9:11 am

MarkyDents wrote: ↑Fri Mar 17, 2023 8:54 am Andy’s Oval front arms were the same width as them.

That would be them, thanks!

So from quick research:
3400 - Lightweight Front (look the same as 3401)
3401 - Wide Track Front
3402 - Lightweight Rear (look the same as 3403)
3403 - Lightweight Rear
3404 - Front Oval / Sprint

Post by **klavy69** » Fri Mar 17, 2023 2:39 pm

I think there are alloy sprint car options out there also. I've got a set of Barts somewhere around here but not sure of their exact measurements. Hot trick had them also along with a few other blingey type brands. The names aren't coming to me right off hand...Then again, I could be off in left field with the ball at 1st base

Todd

RC10Talk - The Net's Largest Vintage R/C Community