Advise on WORLDS RC10 project.

[Bormac]

Hi guys,
I have an RC10 'WORLDs' car and after cleaning it up I'd like to ask for some advise on what parts i should be looking for.
I realy dont like the tie rods that are on this car. They look identical to the early gold pan items and the ball caps look the same only black. What would be a good replacement for this car and where is a good place to start looking?
I also need some bearings for the rear hubs. These have the flanges and Im sure i could find some but if someone might help me with a part number of the imperial measurements of these bearings it would realy help me out.
I dont have a manual for this car either. Is there a manual online for this car by any chance?
Thankyou in advance for any help you might lend me. Cheers-Jason.

[adam lancia]

Go here http://67.199.85.166/resources/resources.php and select RC10 from the drop down list, then click on one of the 3 World's Car links.

[aconsola]

the bearings for the rear carriers should be 1/4x3/8" flanged
Either the early lunsford titanium with the offset nut, or tecnacraft turnbuckles would look great on a worlds car, with RPM rod ends in whatever color fits your build scheme.

[Brandon G]

The newer B4 ballends would work too. A little beefier, black, and they also look a lot like the RPM's w/o the RPM logo.
http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LX3257&P=7

[Charlie don't surf]

Losi makes a nice natural white (but not RPM white) heavy 4/40 ball cup, same length as the
RPM ones, and easy to find if you look hard the bottom worlds car in the pic has em' (before I found NIP AE ones--