CamplinP wrote:Just wondered if anyone has tried the Krylon Fusion paints? (I think that is what it is called) It is supposed to bond with plastics.
I've used it, but bonding with plastics and bonding with Lexan are two totally different things. You probably won't get a good bond to plexiglass with Krylon Fusion.
Hi everyone- 1st post here. Im restoring my old RC10T Sport (the cheap one w/ bushings). The last time the truck ran was around 2004 and has since put in storage. I'd like to add a new body, electrics, radio, etc... From what I unsderstand I can...
Last post
Heres a few that I did recently on my vintage race cars.
Hah, I'm still such a kid. But I figure what good is it to have shelfers sitting downstairs by my workbench when I can have them on the table while I do my work?
After recently nigh on fully refurbishing my old Traxxas Bandit in preparation for racing it. It occurred to me that part of me kinda just wants to put it back on display where it had been for the last 3 years or so after becoming a...
Last post
Right now my only shelfer needs a rx and new saddle pack batteries to run. Its my ltx40 I don't have to worry about the shocks since it doesn't have any. So it just sits.I do need to find a new body for it though snce I accidently cracked the front...
Anyone else do oddball stuff like this when you're wife's not at home to protest? She's gone for the day, I have the kids, and I wanted to see more of my shelfers which are usually on the wall by my hobby workbench in the basement.
So I grabbed...
Last post
there should be a thread where we post photos of our RC cars in places where you wouldn't expect to see them. Kinda like that planking phenomena where photos are takin of people laying across various uneven objects in random place as flat as they...
When disassembling and ressembling I found there to be .003 clearance between the con rod and the crank. Other then that the engine appeared to be new out of the box.
It will make the noise when standing still against my foot with the driveline...
Last post
It doesn't sound like the engine to me. Nitro engines are pretty temperamental and usually wont run if something is wrong .
If it were my truck and you were sure it wasn't something like loose mounting bolts, pipe rubbing the chassis, gear mesh, or...
Here are my two rattle can attempt for my RC10 ladies.
I think it is not to bad for a rattle can :oops:
Would be nice to get feedback from more experienced painter :)
Greetings
Raimund
Last post
I'm no good at painting as I don't have the patience but always find the blending/fading the trickiest bit with cans as the spray patterns are too large.
I assume you used a stencil for the detail in the splashes? I've used cardboard at various...
Need to start playing with my airbrush again, can paint is getting old- IMAG2092.jpg IMAG2115.jpg
Last post
I masked all but the Metallic green, shot that and then trimmed out for the flourescent green and shot it, then cut out the window lines and hit them with yellow and then pulled the rest of the masking off and shot the fade (with a fan on the shell...
I have my usual 3-tone paint job I do... Simple thirds... sometimes front to back, sometimes back to front. Maybe do things at an angle. Just looking to up my game a little.
Anyone have any good simple rattle can tricks to get some good effects?...
Last post
That marble effect sounds cool. I think I may have to give that a try! Thanks.