Start your engines...

Feel free to discuss anything NON-R/C related that is on your mind.

Moderators: scr8p, klavy69

User avatar
askbob
Approved Member
Posts: 1735
Joined: Sun Apr 03, 2011 11:24 am
Location: KY
Been thanked: 3 times

Re: Start your engines...

Post by askbob »

I was looking back on the last couple of years and found a few videos to finally upload. Here was one of my trucks on the dyno after a new tune. Albeit a bit different than that badass Mustang dyno vid!


[youtube]H6gChFqmx-k[/youtube]
[youtube]VD6DFicRrlc[/youtube]

User avatar
GoMachV
Super Member
Posts: 11333
Joined: Sun Apr 29, 2012 10:31 pm
Location: Twin Falls, ID
Has thanked: 823 times
Been thanked: 2419 times

Re: Start your engines...

Post by GoMachV »

The torque those trucks make is unreal. The racers that come down from Canada said they do very little to the engines. They just heat and bend the front axle for camber and lighten them up, they put on a great show! They will melt the tires off down the entire straight!
Quick little video of em
[youtube]QhPXaFg8QOk[/youtube]
Last edited by klavy69 on Wed Jan 02, 2013 2:00 am, edited 1 time in total.
Reason: fixed youtube link
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas
Factory Works website

User avatar
askbob
Approved Member
Posts: 1735
Joined: Sun Apr 03, 2011 11:24 am
Location: KY
Been thanked: 3 times

Re: Start your engines...

Post by askbob »

That's just a road truck, but made over 2200 ft. lbs. Those Canadians, especially in Quebec, are all into the drag trucks.

[youtube]pUVEH7AoEnw[/youtube]
[youtube]sZ8g__S0yhA[/youtube]

User avatar
Russ Winn
Approved Member
Posts: 446
Joined: Sat Nov 20, 2010 9:52 am
Location: Hillbilly Hell, Fl.
Has thanked: 35 times
Been thanked: 53 times

Re: Start your engines...

Post by Russ Winn »

Here's one of my favorite diesels :twisted:

[youtube]9Da1lNy8vvA[/youtube]
The older I get, the faster I was.

https://www.youtube.com/watch?v=pyGKBTUJ-L0

User avatar
PlastiZapCA+
Approved Member
Posts: 746
Joined: Mon Jun 11, 2012 1:41 am
Location: Watauga,TX

Re: Start your engines...

Post by PlastiZapCA+ »

Love this thread!

Chevy v8 in a McLaren M6b
[youtube]KFWGrj5ChsM&f[/youtube]

As a hardcore military modeler and lifetime aviation freak I have to include my favorite beasties! WWII aircaraft engines forever! :P

Crank up the voulume to hear the sounds of the all mighty Rolls Royce Merlin V12 and Pratt&Whitney R2800 aero engines. You must experience these in person to appreciate them fully. These are the sounds of the gods!
[youtube]rRB8fLF6GSQ[/youtube]

B-25 Mitchell with twin Wright r2600's.
[youtube]v4LgaEJgXbU&[/youtube]

And just for fun a monster Wright R3350 on a test stand. This would shake the ground and also shake your guts out! These engines were used in aircraft such as the B-29, Boxcar and Skyraider. Four of these powered the B-29.
[youtube]2d4HQ8ZM_2k[/youtube]

User avatar
LTO_Dave
Approved Member
Posts: 1725
Joined: Tue Mar 03, 2009 3:33 am
Location: Rossiter, PA
Has thanked: 46 times
Been thanked: 225 times

Re: Start your engines...

Post by LTO_Dave »

Just some 1000+ HP AWD dyno pulls for your viewing pleasure:

AMS EVO...recently upped the ante to 1180 AWHP
[youtube]iqEFIMBumJs[/youtube]

Magnus Talon
[youtube]tWR9pYts4iw[/youtube]

Hold on to your hats
[youtube]T7Ppr3Y8Yiw[/youtube]

User avatar
askbob
Approved Member
Posts: 1735
Joined: Sun Apr 03, 2011 11:24 am
Location: KY
Been thanked: 3 times

Re: Start your engines...

Post by askbob »

Love the aircraft! While the SR71 tops my list, this plane is still in action and not talked about very often. I had the pleasure of a few years back of seeing/hearing this plane do a low fly over. Unreal!

[youtube]9f1A3Wt3OtY[/youtube]
[youtube]GJQEk4zGDyc[/youtube]

User avatar
flipwils11
Approved Member
Posts: 1904
Joined: Sun Feb 14, 2010 10:30 pm
Location: St Paul, MN
Been thanked: 15 times

Re: Start your engines...

Post by flipwils11 »

For me the sound of a BMW M1 Pro car at full wail is on a completely different level from other vintage race cars.

[youtube]GbkkxwzK9HE[/youtube]

And then a great vintage racer matchup, the BMW M1 vs a 911 Turbo, neither guy wanting to give an inch!

[youtube]SCx26TFAVbc[/youtube]

User avatar
flipwils11
Approved Member
Posts: 1904
Joined: Sun Feb 14, 2010 10:30 pm
Location: St Paul, MN
Been thanked: 15 times

Re: Start your engines...

Post by flipwils11 »

I know nothing about boats but enough to understand that if I had big dolla's a Fountain Poker Run wouldn't be a bad choice. I love this vid where a Poker Run passes this other boat going flat out.

[youtube]YywDCJWBMDk[/youtube]

User avatar
GoMachV
Super Member
Posts: 11333
Joined: Sun Apr 29, 2012 10:31 pm
Location: Twin Falls, ID
Has thanked: 823 times
Been thanked: 2419 times

Re: Start your engines...

Post by GoMachV »

No matter the form, there is just nothing like horsepower! Keep it coming guys!

My favorite top gear moment (ok, the Robin review was a very close 2nd!)
[youtube]5a1__niLIAQ[/youtube]
Last edited by klavy69 on Wed Jan 02, 2013 1:58 am, edited 1 time in total.
Reason: fixed youtube link
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas
Factory Works website

User avatar
longboardnj
Approved Member
Posts: 1337
Joined: Sun Jun 29, 2008 11:52 am
Location: new jersey
Been thanked: 2 times

Re: Start your engines...

Post by longboardnj »

i cant get enough of this vid and that 2stroke sound.. as far as the ride, who dosnt love a hard hitting 2stroke "powerband". if you never drove a 2stroke do youself a favor and ride one.. i dont care if your "race" 4stroke is faster ,ill have more fun on a 2stroke [youtube]7gZ0NTChjws[/youtube]

User avatar
askbob
Approved Member
Posts: 1735
Joined: Sun Apr 03, 2011 11:24 am
Location: KY
Been thanked: 3 times

Re: Start your engines...

Post by askbob »

[youtube]B9zt3SF_Flc[/youtube]

User avatar
LTO_Dave
Approved Member
Posts: 1725
Joined: Tue Mar 03, 2009 3:33 am
Location: Rossiter, PA
Has thanked: 46 times
Been thanked: 225 times

Re: Start your engines...

Post by LTO_Dave »

Any buggy driven by Tim Cameron sounds good:
[youtube]eeXoOrbmMpg[/youtube]


When Bob's not building sweet RC10's, he's using one of these to cut down giant trees :mrgreen:
[youtube]JjXw--3jCv4[/youtube]

User avatar
flipwils11
Approved Member
Posts: 1904
Joined: Sun Feb 14, 2010 10:30 pm
Location: St Paul, MN
Been thanked: 15 times

Re: Start your engines...

Post by flipwils11 »

LTO_Dave wrote:Any buggy driven by Tim Cameron sounds good:
Sorry I couldn't hear anything other than the voice in my head telling me he was an idiot for not wearing a helmet.

User avatar
Coelacanth
Approved Member
Posts: 7370
Joined: Thu Jul 29, 2010 6:20 pm
Location: Alberta, Canada
Has thanked: 16 times
Been thanked: 289 times

Re: Start your engines...

Post by Coelacanth »

I've had this in my YouTube Favorites for years, I still get heart palpitations hearing that Hemi wind up. Watching this highly-modified Challenger reel in and pass Porsches & Ferraris is just the gravy!

When you can get a Challenger to handle like that, it's like when Happy Gilmore learns to putt....watch out! :lol:

[youtube]7D4dpsC8eVE[/youtube]
Completed projects: CYANide Onroad Optima | Zebra Gold Optima | Barney Optima | OptiMutt RWD Mid
Gallery - Coel's Stalls: Marui Galaxy & Shogun Resto-Mods | FrankenBuff AYK Buffalo | 1987 Buick GNX RC12L3

Post Reply

Create an account or sign in to join the discussion

You need to be a member in order to post a reply

Create an account

Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute

Register

Sign in

  • Similar Topics
    Replies
    Views
    Last post
  • Engines
    by Coltonw » » in RC10 Truck Forum
    7 Replies
    266 Views
    Last post by coxbros1
  • Various model V8 engines
    by kink » » in Off-Topic / Chit-Chat
    2 Replies
    473 Views
    Last post by marlo
  • Which R/Cs used 4 stroke engines?
    by Grunger73 » » in R/C Off-Topic / Chit-Chat
    9 Replies
    1126 Views
    Last post by Puffdogg
  • Help with timlline of engines
    by Stibing » » in Vintage Electronics
    2 Replies
    695 Views
    Last post by jwscab
  • What nitro engines to keep for RC10GT2?
    by mAdMan » » in 21st Century Modern
    4 Replies
    1248 Views
    Last post by klavy69
  • RC10GT - Where have all the nitro engines gone?
    by RC10th » » in RC10 Truck Forum
    6 Replies
    1540 Views
    Last post by RC10th
  • World Engines Mercury Xi-4
    by tamiyadan » » in Other Makes/Models
    1 Replies
    857 Views
    Last post by Mr. ED
  • World engines cx 12 1/12 1971
    by speedemall » » in Other Makes/Models
    1 Replies
    1119 Views
    Last post by Eau Rouge

Return to “Off-Topic / Chit-Chat”

Who is online

Users browsing this forum: No User AvatarFacebook [Bot] and 39 guests