Hello again,
Tried to search the site but the search does not like the word tire or wheel. So I was looking for tires and am I correct in assuming that I can no longer get tires for 2" rear wheels? At some point I upgraded the wheels on my original Gold Pan and the fronts are 2.2" but the rears are 2". I have a set of Proline Strikers mounted both front and rear which look to be in good shape with plenty of tread but I imagine I will need tires eventually with the new found Lipo Brushless power
JC Racing are now offering their rear 2.2 YZ10/870C wheels as a pair, so if your looking for a set for your RC10 you no longer need to buy unwanted fronts to get the rears 👍
I have been lurking on here reading up on how to get my CE gold tub (I wanna say 6011 because of the bushings) driving again. It is in pristine condition considering that the only reason it was not run when I was young is because my brother botched...
Last post
Got some pictures of the wheels an how they fit using the drilled out SC10 hex adapters and the mini e-revo wheels
Guys, I have an RC10B2 that I bought right when they came out. It came with 2.15 rear wheels (which are still on it). The Associated PN in my book is 9490, I recently picked up a new set of 9490 wheels and they are a little larger (2.2 ), like my...
Last post
Same wheel in 2.2, same pin and I.D. as well- works fine
Since Tower is not able to supply B2/B3 rear wheels any more (discontinuted) is there an alternative we can use for racing? I had a look at the Thunder Tiger Phoenix BX wheels because TTR stated that this buggy is based on the AE B3 but it...
Last post
I tried fit the rims on the CVDs i have, and they appear a tad small. I think a simple pass of the 3/16 drillbit should take care of it.
MOmo
Had to do the same thing for the ones I used. I Put a 1/4 inch bit into the back of the wheel just to...
I'm just playing around with the Idea but I'm considering trying to run a set of alloy rear wheels on the front wheels. I'm not trying to do a 4wd kit but could be open to the idea. Id like the car to be drive able after done.
im thinking if i cut...
Last post
well, back at square one. the seller was missing one of the axles in the set so I'm getting a refund :(
ill keep the b4 setup in mind until i find another set of axles that are cutoff at the end.
Hey guys. I'm looking for ideas on any tires that might fit the original RC10 1.6 rear wheels. I've heard people have used Tamiya Hornet tires or Sand Scorcher tires. Are there any other ones out there? Seems like all the re-release stuff has dried...
Last post
There are some JConcepts for the classic 1.7 rear wheels.
Maybe not the old school style but probably a better all round tire for traction.
