I finally cut the seal and built my B44 kit after having it for two years. And I wanted to take some pics because it will never look this clean again. I put the Orion brushless system and 2.4GHz receiver from my RC10 into my B44, along with Orion 5300 SHO cells. And I added a Trinity Psychotic Reaction 13T mod and a graphite TrackMaster Turbo Glide tranny because my RPM Stealth went boom.
My friends and I almost finished my backyard off-road track today, so of course we had to test it out even though it rained a little. It now has a Diggity Designs LiPo tray so I can use my giant TrakPower saddle packs.
I just got some new DE Racing Borrego wheels and Schumacher yellow-dot full spikes for my B44, and wanted to snap some pics before I do some weed eatin' with them. :
Well not maybe my first post with picture (First was in BST, hahaha...) so here my ( what was left of my Vintage) RC10 Graphite Modern Runner 2.2
Not much but i think i need to post it before the Wife decides its faith to sell or not.. (huhuhu)...
Last post
Just bumping this thread.
as it sits now.
Like to do some mods.
-Allu Tranny- Done
-Allu Gear Diff
-Allu Idler Gear RRP
-SC10 Hex Mod
-Allu Rear Bulkhead
-Allu Rear Arm Mounts
-CF Tub ( in the works, will post pics when I have em). +8mm...
So I built a beat A stamp car into the CE I had as a kid, but with 12mm hexes and the trackwidth pushed out to ROAR maximum. Im using RPM ballcups and the newer style associated ball studs on the front and am having a problem with the inner camber...
Last post
Yes! Those are the business! i have been wanting to do a transverse steering servo to move the battery forward anyway! I had started filing and grinding on a b4 bellcrank set but i was worried about the posts bending and didnt want to add a top...
Just picked this up over the weekend from Norman here on RC10talk. It's an A-stamp chassis drilled for a Stealth trans with white long arms up front and a World's bulkhead, and all original plastics except the rere World's steering. Here's the rest...
Last post
Sounds good Joey, lets try it!
I'll hold off on the 25 degree blocks for now then, I thought they would help it, not hurt it.
This is my start to a gold pan runner build. Milled the chassis at work and rounded over back of chassis where it attaches to the motor and also rounded over the nose piece and cut it the same shape as the 6309 nose. Then sanded edge of chassis all...
Last post
Added the battery strap today and got the turnbuckles and ball ends a cleaned and installed. I will eventually add titanium turnbuckles but these will be fine for now.
i know this is on the new side but i had to share. i got this body off ebay and tracked down jeff on FB. he did say it was his body and he did sign it. he said it was used on his b44.1, but from what i can see by the 2 rear body holes and velcro...