I was a cheapo back in the day, I used brass strips! Worked fine for sport use
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas Factory Works website
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas Factory Works website
Hello all,
I recently receieved my new promatch energ 4600 7-cell battery and had my first run on my re-buildt RC10t. I'm running a dynamite tazer 15t esc and a new 17t motor. I was maybe 5 minutes into my bashing session when the truck just...
Last post
Well, its good to know that the cheap 'deans' on the bay are knockoffs. I've used ultra's on both motors and batterys for years with no regrets.
I do think the 'Traxxas' connectors are the future of, at least, sport RC. Lastly, i've heard that...
I am a newbie in RCs and Li-Pos, I only ran NiCds in the past and very little of that. I am just finishing cleaning and restoring (not full restore just bearings etc) my RC10T and I just got my first Li-Po batteries (Gens Ace 4000mAh 25C #2S1P) and...
Last post
I found that if you first generously tin the connectors on the deans connector.
Then you tin the wires and let them both cool down.
Now heat the wire and add enough solder to make your connection the bring the soldering iron and the wire together...
I made my first purchase of Li-Po packs two weeks ago and was surprised by the wire gauge used. They were Turnigy 2S 30C 5000MAh and have 8ga wire. I wondered if others used Deans with this size wire and did post the question on RC Universe and...
Last post
my friend just picked up some turnigy 5000mah 25c 2s packs. wtf is up with the wire.... I wonder if they had some lawsuit against them having something to do with skimpy wire at one time so they decided to use something I might power a decent amp...
are any of you running them on your racers? i run my rc10 on astro and in tight 180's off a fast corner the car will pick up in the inside front wheel as its transferring to much weight to the outer rear wheel.
im using rpm worlds arms and was...
Last post
i have some coming. i will post up as soon as i have them on.
hey all i know i could easily make sway bars for my gt but i wanted to know if any mfg ever made sets for the older black tub
thanks
Last post
Here's mine. Endlinks are from the associated t4 rear swaybar kit. Lower mounts are just a long ballstud with a spacer between the aluminum ends. Bulkhead is all stock 10GT. I took the kit swaybars and spread them out a bit and just used music wire...