As per title, an early esc by I & D electronics, also responsible for the Spectron lexan car. Haven't had a good look at it yet or tried to see if it works. The Parma motor looks to have been supplied by MG.
It's not overly massive considering it's in a case.
On resistance is just that, how much resistance the unit adds between the battery and the motor at full on throttle. A lower number is better, closer to just a direct wire, less voltage & power loss. Don’t remember offhand what a good number for...
I have another on of these in my old dragster. Just don't remember the name. Anyone know??
Last post
those black magic motors are no joke. i remember i had a couple, and i also remember writing off two rc12l's and a rc10l with them. it was like putting a v12 in a gokart.
Need some help. I have recently found my old RC cars at my parents and have fully refurbished the first one from early -90s. The car is a electric raider outlaw.
After replacement of mechanical parts and a new 7.2V 3000mah battery it...
Last post
Even a good vintage ESC can be had pretty cheaply these days. On my old Raider I ran a Futaba MC112B. I just picked up a vintage one that looks like it was never used, for like $25. The nice thing about this ESC, is it mounts just like a servo,...
How hot a motor you guys think I can run on that esc that comes in alot of the re-re kits before it lets the smoke out?
Last post
ive seen people running the 19t trinity komodo conservativley geared. i ran it with my hotshot re-re for a while with the 17t pinion and it worked just fine. didnt get too hot on me, neither the motor or esc.
Just got this gem in the mail today. Popped off the wiring cover and discovered this:
And we've been wasting money on speed controls. You could have just hooked the motor straight to the receiver like this!
Can't imagine this worked too well......
Last post
Ummm.....no you can't do that! The white wire is a pulse. Black and red are power and ground. You don't have anything there to control power with. The esc is not just an amplifier, it processes the signal.
Can anyone tell me if the Novak 1 came with heat sinks please? The kind that slip on over the ones molded in the case?
Last post
Heat sinks were an optional part - not needed for 12th scale but needed for 10th off road. Two (black) heat sinks - one longer one for most of the FETs, a smaller one for the single brake FET on the right.