Trying to replace a broken ball cup. Looks like I can use the RPM Heavy duty ball cup (#73372) that fits my 0.168 ball, but I was wondering what turnbuckle this fits. I have both original steel and titanium turnbuckles I bought back in 1990. The...
Last post
Those ball ends fit my late Edinger's threaded rods perfectly, and I think they are the same pitch. Also, I beleive the kit stock ball ends are the same between the two.
I have one of the graphite chassis that has the AE symbol etched in it and have a question about re-conditioning it. It is in great shape other than the very front being a bit frayed on one side from one or more hard crashes. I got it off ebay for...
Last post
I just did the same to my chassis. To get the glue off I soaked the spot with acetone and used a sharp chisel layed down flat against the chassis. Worked great!
I figured the only way to get a coffin chassis RC10 Graphite is to have a replica chassis made. Since I have an extra later model RC10 Graphite in nice condition, it seems like a good option for the making a coffin chassis style buggy.
Disclaimer...
Last post
I decided which one gets the skeleton chassis and 48p Thorp 6 gear setup.
.
PXL_20230921_154526689~2.jpg
.
PXL_20230921_155143944~2.jpg
.
PXL_20230921_155511891~3.jpg
.
PXL_20230921_162536099~2.jpg
Could you guys tell me the differences between a regular RC10 Graphite and a RC10 Graphite Team car besides the obvious...teflon shocks and stealth tranny? thanks in advance!
Last post
Thanks guys I found exactly what I needed thanks to you guys. I appreciate it.
Just wondering about the part on the chassis that attaches the motor plate to the chassis. It's the part right at the back - are these available anywhere? I figure eBay is the only place but I don't even know what it's called.
Last post
Thanks buddy - that is exactly what its called. Didn't find any on ebay yet, just B4 ones.
I always seem to cross those ones 
Mojeek [Bot] and 39 guests