I've been wanting to run big bore springs on my JRX Pro for a while due to the variety of spring rates available. I've got tons of big bore springs and this way is far cheaper than converting the car to big bore shocks. I modeled these up and am...
Last post
I've completed a model tree for the big bore spring adapters for standard bore Losi shocks. It has a set of 4 of each part. There are 4 collars, for those who have the smooth bodies. There are 4 bottoms, for all shocks. Finally, there are 4 rings....
I bought a set of shocks but don't know how to put them together :oops: I have looked for a video on you tube and looked for better instructions that cam with them but can't find anything. I just don't understand the instructions that came with...
Last post
While on the subject... Do the big bores use the same size O-rings as the V2 shocks?
I want to install big bore shocks on my Worlds RERE. What shock towers do I use? I think the standard ones are not the right size for big bore. Also, what does big bore actually mean? Thank you.
Last post
I use Big Bore shocks from the Associated B6. They are around 38-40 dollars a set on eBay. Comes with everything, including springs.
Where are you getting a complete set for that?
It was a chop shop on eBay. They were selling B6D shock sets. I...
Dangerous thing, but I got to thinking today while browsing eBay. Has anyone tried fitting current 10th scale big bore springs to older 8th scale shocks...? I know most were a 13mm inner bore but I wonder if the spring diameters would be close...
Hey guys, I’m setting up an RC10 to run at my local Clay track. I plan on putting some big bore shocks on it that I took off of a B5m. I’m looking for some basic set up Tips since I know several of you guys have run big bore shocks on your RC10s....
Last post
I need to test more but, I used shocks from a B5 with factory works towers. I used kit pistons with 30W oil. My suggestion is to measure your current droop setup and match that with your new setup. I liked green springs front and rear but, tune to...
I'm sure this has been asked before but I'm feeling lazy right now Lol. Which big bores fit the 10t? Can someone post a pic of a set of any shocks on the back side of the tower?
Last post
This is nice I was looking into getting newer threaded shocks for my build but I'm thinking of going to big bores now after seeing this thread.
I know someone has probably asked before but what shocks off the new associated models will fit the rc10t? Are they bolt on or do I need to make modifications?
Last post
A better option might be to run these on the front.
That's the stock 10T bottom ends... I don't think it will alleviate the issue. But then again, one has to try to see how it all nets out.