Incredible_Serious wrote:3. They look like front wheel bearings - did the Ultima2 run flanged bearings in the front wheels?
Thanks for info.
I went over the manual to check what the front wheels originally came with. 4x8mm bushings (2 per wheel). They are NOT flanged. I replaced those with 5x11x4mm bearings when I upgraded to the 2.2" Tamiya wheels and CRP axles.
I also went over the bearing kit to see what I have left. These flanged bearings are the same size as the front wheels, except they're flanged. I also have left over (4) 6x10x3 bearings. I thought those were the front wheel bearings, but now I see they're not the right size. So what could those be for? I don't see any bushings that size listed in the manual. The only bushing that didn't get a replacement was a long 4x8 that goes on the center gear shaft.
This is what came in the bearings pack and where they've been used so far...
(2) 8x14x4 - (2) diff
(6) 5x10x4 - (2) gear box, (4) rear wheel shaft
(4) 4x8x3 flanged - ???
(4) 6x10x3 - ???
And lastly, in the process of writing this post I checked to see what the original Kyosho bearing kit KYOC2194 brings...
(2) 8x14x4
(6) 5x10x4
(6) 4x8x3
From the picture and description, nothing looks flanged. It doesn't have any 6x10x3, and has 2 extra 4x8x3.
At this point I'm assuming these extra bearings are for different models and I have all the important bearings in. I'm inclined to delete the wall of text above, but I think I'll leave it for future reference.